ASG DTT Series Panduan Pengoperasian - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Peralatan Uji ASG DTT Series. ASG DTT Series 12 halaman.

Following are the functions of the buttons when in normal operating mode.

In normal operation, pressing the RESET button resets the torque readings to zero in

either the PEAK or FIRST PEAK mode.

Note! In TRACK MODE pressing the RESET button will take you into the MAIN MENU.

Press the button again to ESCAPE back to the previous screen and press the MODE

button to return to PEAK or FIRST PEAK Mode.

Button #1: MENU, RESET/ESCAPE

In normal operation this is the reset button. Press to reset the display to zero

prior to taking a torque reading.

Button #2: MODE

In normal operation, the MODE button is used to change the MODE setting of the DTT

meter. Each time the button is pressed the mode will change from TRACK mode to

PEAK, or from PEAK to FIRST PEAK, or from FIRST PEAK to TRACK.

Button #3: UNIT

In normal operation, this button changes the torque units of the meter. Pressing the

button will scroll through the 9 choices. Kgf-cm, gf-cm, Kgf-m, mN-m, cN-m, N-m,

ozf-in, lbf-in, lbf-ft, in this order. Do not attempt to back up by pressing the DOWN

button; you will only change the mode.

Button #4: MEM (Memory)

In normal operation, pressing the MEM button enters the torque reading into the DTT

memory.

OVERLOAD CAPACITY

Do not deliberately exceed the capacity of the unit. The maximum capacity of

the DTT meter can be found on the spacer ring surrounding the transducer

The overload capacity of a DTT meter is 200% of its maximum load capacity. If the

meter is taken over capacity; a warning tone will sound, the word "OVERLOAD" will

flash on the LCD and the unit will LOCK until the RESET button is pressed.

Immediately stop applying torque when the overload warnings are observed.

A unit subjected to overload, or subjected to harsh conditions such as use with an

impact tool will not be covered under warranty.

Attach a proper adapter to connect the driver to the 3/8" female square. NOTE IT IS

NOT RECCOMMENDED TO USE THE POWER TOOL ADAPTORS TO CALIBRATE

HAND TORQUE TOOLS

Select FIRST PEAK mode using the "MODE" button. Press the "RESET / ESC"

button if the display is not at 0.

Turn the driver or wrench clockwise or counterclockwise until the "break" point is

reached. In FIRST PEAK no other reading can then be displayed until the reset button

is pressed.

CAUTION!