ASG X-PAQ ASG-NW2500-EIP Panduan Pengguna - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Unit Kontrol ASG X-PAQ ASG-NW2500-EIP. ASG X-PAQ ASG-NW2500-EIP 15 halaman. Ethernet ip network communication module
Halaman Cetak
Program Mode:
The escape key (ESC) will send the program back to the main screen without at-
tempting to read the password. If the enter key (ENT) is pressed, the unit will com-
pare the entered password to the password that is stored in the unit's non-volatile
memory. If these values match, the unit will continue onto the programming menu.
Programming the Unit's IP Address:
There are several items that are user configurable through the
programming menu. In order to reach this menu from the main
display, press the enter (ENT) key.
The display will prompt the user to enter a password before
reaching the programming menu. The default password is "0 1
0 4".
While entering the password, the left and right arrow keys will
move the cursor back and forth. The up and down arrows will
raise and lower the value of the digit that the cursor is high-
lighting.
It's important that each device on the network has it's own unique IP
address. In order to edit this interface's IP address, select Program-
ming IP Address from the main menu and press enter.
The current IP address will be displayed at this point. In order to
change the address use the LEFT and RIGHT arrow keys to select any
given digit in the address and then use the UP and DOWN keys to al-
ter that digit's value.
Once the desired IP address is displayed, the enter key can be
pressed to save that value. All programmable values are stored in
non-volatile memory. This allows the unit to "remember" these values
even when the unit is turned off and unplugged. The escape key can
be pressed any time during the editing process allowing the user to
return to the main menu without saving a new value. For a new IP
address to take effect, the unit's power must be cycled off and then
back on.
8