Doka Shifting wheel KS Petunjuk Pengoperasian - Halaman 3
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian untuk Peralatan Industri Doka Shifting wheel KS. Doka Shifting wheel KS 3 halaman.
Halaman CetakOriginal Operating Instructions Shifting wheel KS
Horizontal repositioning
Wheeling
The Shifting wheel KS makes it possible for Column
formworks KS Xlife of up to 3.60 m in height to be hori-
zontally travelled.
It can be clamped to 2.70 m and 3.30 m high panels.
4 Shifting wheels KS are needed for repositioning 1
Column formwork KS Xlife.
The following points MUST be observed –
otherwise you risk the formwork tipping
over
▪
Do not attempt to wheel any Column form-
work KS higher than 3.60 m.
▪
Only wheel the column formwork when it is
CLOSED – fix it in the closed position with a
Locking hook KS.
▪
The floor must be stable, firm and sufficiently
smooth (e.g. concrete).
▪
Max. speed 4 km/h (walking pace)
▪
Either bridge any openings in the floor with
sufficiently strong planking/boards secured
so that they cannot slip away to either side,
or close off openings with sufficiently strong
side railings!
▪
Keep the travel route clean and free of any
obstacles.
▪
It is forbidden to wheel the column formwork
when the wind-speed is higher than 45 km/h
(over 0.1 kN/m
4420).
▪
It is forbidden to use any mechanical assis-
tance during the wheeling operation!
▪
"Passenger transportation" is forbidden.
▪
In the "parked" position, always lower the
Column formwork KS using the spindles.
999237002 - 05/2016
impact pressure to DIN
2
9746-321-01
Using the spindles, raise the Column formwork KS
➤
Xlife around 2 cm off the ground.
When wheeling the formwork, always have 2 people
➤
pushing (1 on either side).
EC Declaration of Conformity
pursuant to EC Directive 2006/42/EC.
The manufacturer declares that by reason of its conception and
design, the following product
Shifting wheel KS, art. n° 580358000
conforms – in the version marketed by ourselves – to the pertinent
fundamental health and safety stipulations of the relevant EC Direc-
tives.
The following harmonised standards were applied:
▪
EN ISO 12100:2010
▪
EN 349:1993+A1:2008
Person authorised to compile technical documentation
(pursuant to European Directive on Machinery Annex II):
Ing. Johann Peneder
Josef Umdasch Platz 1
A-3300 Amstetten
Amstetten, 3 May 2016
Ludwig Pekarek
Executive Manager
9746-336-02
Doka GmbH
Josef Umdasch Platz 1
A-3300 Amstetten
Johann Peneder
Authorised Officer, Head of R&D
3