CYP PU-O4H4C Panduan Pengoperasian - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pengalih Matriks CYP PU-O4H4C. CYP PU-O4H4C 12 halaman. V1.3 hdmi 4x4 matrix with built in hdmi over cat6 outputs
Juga untuk CYP PU-O4H4C: Panduan Pengoperasian (16 halaman)
Halaman Cetak
4.2 Rear Panel
EDID
STD
TV
DDC
1
2
1. EDID Control Switcher: Default factory setting is on TV, leave as it is when the
display is displaying properly. Switch to STD to use built-in EDID.
Note:
1. When EDID is switched to TV, the unit will detect the first HDMI output source's
EDID and record it in the unit. If the first detected output source is DVI, it will
skip onto the next source until the first HDMI source is detected. The detection
priority is HDMI v1.3 > HDMI v1.2 > DVI.
2. When EDID is switched to STD, the unit will use its built-in EDID that supports:
Video 1080p 12-bit (max) supports xvYCC Audio PCM 2CH
3. The EDID selection will only be activated after the unit is re-plugged and
powered on.
2. RS-232: This slot is where you connect a D-Sub 9-pin cable to the PC COM port
when controlling the device over RS-232. Detailed specifications are listed in
section 9.
3. Video/DDC CAT 6 outputs: These slots are where you connect two CAT6 cables
to a receiver box that has HDMI output and through the HDMI output it can be
connect to TV. The receiver box can also be a splitter that provides additional
CAT6 outputs when cascading from a HDMI receiver to the display via HDMI
cable.
RS-232
CAT6 OUTPUT
D
VIDEO
DDC
C
VIDEO
DDC
B
VIDEO
DDC
3
IR OUT
4
3
4
3
A
VIDEO
HDMI INPUT
4
Page 3
2
1
DC 5V
IN
2
1
5
6
7 8
IR MAIN
OUT