CYP CH-1602RX Panduan Pengoperasian - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pemancar CYP CH-1602RX. CYP CH-1602RX 15 halaman. Hdmi over hdbaset transmitter and receiver with optical audio return (oar)
Juga untuk CYP CH-1602RX: Panduan Pengoperasian (16 halaman)

CYP CH-1602RX Panduan Pengoperasian

6.3 Receiver Front Panel

POWER AUDIO OUT IR IN1 IR OUT2
1
POWER LED: This LED will illuminate when device is connected with
1
USB power supply.
AUDIO OUT L/R: Connect to speaker with RCA input for audio
2
signal output.
IR IN 1: Connect to the supplied IR Extender cable for IR signal
3
reception. Ensure that remote being used is within the direct line-
of-sight of the IR Extender.
IR OUT 2: Connect to the supplied IR Blaster cable for IR signal
4
transmission. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled.
USB: Connect to USB peripheral devices such as printer, keyboard,
5
flash driver or ...etc. for data receiving or sending back to
Transmitter.
RS-232 OUT TX/RX: Connect to the device that is to be controlled
6
via 3-pin Relay cable by RS-232 commands. For sending command
to Transmitter side, the TX and Rx pin must be reversed.
UPDATE: This is reserved for firmware update use only. Switch
7
this deep switch to left for firmware update use, under normal
operation, leave the switch on right. Update procedure may be
done from the same USB port for both Transmitter and Receiver.
5
L
R
2
3
4
USB
USB
5
RS-232 OUT
UPDATE
TX
RX
6
7