Dolby Audio ZVOX SB380 Panduan Penyiapan & Pengoperasian - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Penyiapan & Pengoperasian untuk Sistem Pembicara Dolby Audio ZVOX SB380. Dolby Audio ZVOX SB380 12 halaman.
Halaman Cetak
Button Functions on the
ZVOX Remote Control
Power
Changes the ZVOX speaker between OFF
& ON.
Note: The ZVOX SB380 will enter Standby if
it receives a weak enough or no audio signal
for approximately 20 minutes. A command
from a remote control or a restored audio
signal will turn it back on.
Volume
These appropriately named buttons control
the volume up, down & also used to adjust
the different "Other Settings" adjustments.
Input Selection
Press the INPUT button on the ZVOX
remote to select between the speaker's
input modes.
The Input Selection Sequence:
Optical digital — IN1d
Optical digital IN2d
RCA Analog minjack — In3A
Voice Assistant System Use Only — both*
Remote Control Button Layout.
INPUT
POWER
ACCUVOICE
SURROUND
MUTE
VOLUME
Surround Settings
There are three SURROUND levels:
• Surround One ("Sd 1") has low virtual surround
effect and strong vocals. Use this setting if vocal
clarity is important to you.
• Surround Two ("Sd 2") has moderate virtual
surround effect and moderate vocals. This is the
recommended setting for general TV programs.
• Surround Three ("Sd 3") has strong virtual
surround effect and moderate vocals. Many
people prefer this setting when watching movies.
Note: For high fidelity sound use this feature. Pressing the Accuvoice button
disables the surround sound setting.
Using Voice Assistance System Input Feature (both)
It's simple to integrate an Amazon® Echo®, Echo Dot or Echo Input to the SB380. Connect your TV to Input 1.
Connect the Echo device (via 3.5mm cord) to Input 2, then set input selection to "both" by cycling the INPUTS or
pressing and holding the INPUT button on the ZVOX remote for five seconds (Hard Hold). If you are watching a TV
program and ask "Alexa" a question, the SB380 will turn down the TV sound while Alexa answers your question.
When Alexa will stop speaking and the SB380 will turns up the TV sound.
To switch back to the regular inputs In1d, In2d or In3a, tap the input button to cycle until you have sound or press
and hold the INPUT button for five seconds, then cycle the inputs for sound.
Note: If the "both" input is mistakenly enabled without an integrated Amazon® Echo®, Echo Dot or Echo Input
setup you may hear normal audio but the ZVOX speaker may act abnormal, change the input when not in use.
Mute
Tap this button to mute the ZVOX speaker. When MUTE function is
active, the display blinks "-00-". The SB380 will enter Standby if it is
left in MUTE for longer than five minutes.
AccuVoice
Press the AccuVoice button to select the AccuVoice function. Additional presses of
the AccuVoice button allow you to select increasing levels of voice enhancement.
There are six levels of increasing voice enhancement, starting with AC 1 going up to
AC 6. The setting you select remains the default AccuVoice setting until you decide
to change it.
Note: Pressing the Surround button removes the Accuvoice boost feature.
UP TO