CYP CH-507RX Panduan Pengoperasian - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Penerima CYP CH-507RX. CYP CH-507RX 16 halaman. Hdmi over cat5e/6/7 transmitter and receiver
Juga untuk CYP CH-507RX: Panduan Pengoperasian (11 halaman), Panduan Pengoperasian (16 halaman)
Halaman Cetak
6.2 Receiver Front and Rear Panels
Front
Front
HDMI Out
HDMI Out
1
1
2
2
1
HDMI Out: Connect to a HDMI equipped TV/monitor for display of the
HDMI input source signal.
2
LAN: Connect to a PC or Laptop to the Internet or network connection.
3
RS-232 Out: Connect to the device that is to be controlled (via D-sub 9-pin
female cable) by RS-232 commands.
4
Power LED: This blue LED will illuminate when the receiver is receiving
a power supply via PoC from a compatible transmitter unit.
5
IR2 Blaster: Connect to the IR Blaster cable for IR signal transmission.
Place the IR blaster in direct line-of-sight of the equipment to be
controlled.
6
IR1 Extender: Connect to the IR Extender cable for IR signal reception.
Ensure that remote being used is within the direct line-of-sight of the IR
extender.
7
Link LED: The yellow LED will illuminate when both the input and output
signals are connected.
8
CAT5e/6 In: Connect to the transmitter unit with an single CAT5e/6/7
cable for transmission of all data signals.
Receiver
Receiver
RS-232 Out
RS-232 Out
CAT5e/6 to HDMI with LAN/IR/RS232
CAT5e/6 to HDMI with LAN/IR/RS232
3
3
Rear
Rear
IR2 Blaster
IR2 Blaster
Power
Power
IR1 Extender
IR1 Extender
4
4
5
5
6
6
7
7
8
8
4 4