CYP CH-1601TXRX Panduan Pengoperasian - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pemanjang CYP CH-1601TXRX. CYP CH-1601TXRX 20 halaman. Hdmi/audio over cat5e/6/7 extender with 48v poh
Juga untuk CYP CH-1601TXRX: Panduan Pengoperasian (15 halaman)
Halaman Cetak
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter's Front Panel
RS 232 IN
UPDATE
1
2
Update Switch
1
Switch this deep switch to right for firmware update use, under
normal operation, leave the switch on left.
2
RS-232 IN
Connect to a PC or Laptop with D-Sub 9- pin female cable for the
transmission of RS-232 commands.
3
IR IN 2
Connect to the supplied IR Extender cable for IR signal reception.
Ensure that remote being used is within the direct line-of-sight of
the IR Extender.
4
IR OUT 1
Connect to the supplied IR Blaster Cable for IR signal transmission.
Place the IR Blaster in direct line-of-sight of the equipment to be
controlled.
5
LAN
Connect to internet or network service system to this slot or to the
LAN port slot of the equipment device for a total sharing rate of
100Mbps within the link. The yellow LED will illuminate to represent
the link with Receiver is steady, when it blink irregularly it represent
the link error or when not illuminate it means no link with Receiver.
The green LED will illuminate to represent the Ethernet speed is with
100Mbit/s.
6
CAT5e/6/7 OUT
Connect to the Receiver unit with CAT5e/6/7 cable for transmission
of all data signals. The yellow LED will illuminate to represent the
link between Transmitter and Receiver is steady, when it blink
3
IR IN 2 IR OUT 1
LAN
3
4
5
CAT5e/6/7 OUT
DC 48V
6
7
POWER