Ashford EDC30 Petunjuk Manual - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Alat Tenun & Aksesori Ashford EDC30. Ashford EDC30 6 halaman. E-carder 30cm wide dual motor

Halaman Cetak

FEATURES

The EDC30 allows you to prepare batts up to 150gms (5.5oz) quickly and efficiently. It is ideal for spinners and

felters. The packer brush helps transfer fibres from the small to large drum and pack the carded fibres into the teeth

of the large drum. This allows more fibres to be carded and results in a thicker batt. The packer brush helps control

fine low crimp fibres such as mohair, angora and alpaca.

The variable speed ratio gives flexibility and control when carding and blending. Use a lower/slower ratio to card

fleece. The controlled intake and carding will produce a smooth even batt ready for blending, spinning or felting. Use

a higher/faster ratio for re-carding a batt, blending sliver, colours and different fibre types consistently into an open

and airy batt.

Always use the push stick included with the EDC30 so you can safely feed fibre up to the small drum. Use the doffer

to split the batt at the aluminium strip and the cleaning brush to clean the drums between batts.

The adjustable drum clearance allows you to set the teeth distance for total control of your fibre. The drums have

already been set to the correct spacing in our factory and should not require any further adjustment. Both shafts run

in low friction nylon bearings. The card cloth has wire teeth with a special protective coating and a flexible rubber

backing for long life. The small drum has 36-point card cloth to allow the fibres to transfer easily to the large drum.

The large drum has 72-point card cloth.

The carder is strong and robust with the body made from Beech hardwood and has rubber feet to prevent it slipping.

It is supplied assembled and lacquered ready for use.

CONTROL PANEL

24Vd.c.

ON/OFF

• Always turn the power OFF when the EDC30 is not in use.

• The red light on the switch will indicate the power is on and is ready to use.

• Even ON-OFF flash - indicates the carder is ready to operate in the FORWARD mode.

• Constant ON - the carder is operating normally.

• Fast ON-OFF flash - indicates the carder is ready to operate in the FORWARD Blending mode with the safety cover

off.

• Short ON Long OFF flash - indicates the safety cover has been removed and the carder will not run in the

FORWARD mode.

NOTE: The motors have a soft start to reduce the starting load.

RUN-INCH

Push this button to turn the power ON or OFF when operating the EDC30.

SPEED

This dial controls the speed of the large drum from 0 to approx. 120rpm. It automatically increases or decreases

the speed of the small drum to maintain a constant drum ratio. Start slowly and turn the dial clockwise to gradually

increase the speed so that you can keep up whilst feeding the carder. This is generally between 60 - 80% of the

maximum speed.

DRUM-RATIO

This controls the speed of the small drum from 0 to approx. 5rpm. Turn the dial clockwise to gradually increase the

speed. Adjust the speed of the small drum for the optimal drum ratio. When carding fleece use a very low/slow ratio

to maximise the carding action. For the second pass when re-carding or blending sliver, use a higher/faster ratio.