CYP CHDBT-1H7CE Panduan Pengoperasian - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Kabel dan konektor CYP CHDBT-1H7CE. CYP CHDBT-1H7CE 13 halaman. 1×8 hdmi over hdmi and cat5e/6/7 splitter
with poe and lan serving
Juga untuk CYP CHDBT-1H7CE: Panduan Pengoperasian (16 halaman)
Halaman Cetak
5
IR IN: Connect with IR Extender to receive IR signal from Transmitter
side and blast out at Receiver side. Ensure that remote controller
being used is within the direct line-of-sight of the IR Extender.
6
IR OUT: Connect with IR Blaster to blast out the IR signal received
from the Receiver side. Place the IR Blaster in direct line-of-sight of
the equipment to be controlled.
7
EDID STD/TV: The default factory setting is on TV, leave as it is
when the display is properly. The unit will detect the 1
output's EDID when it obtain a 4Kx2K EDID and send out the signal
accordingly to other output ports. If the 1
without a 4Kx2K's EDID the unit will detect all output's EDID and
send out the signal that all outputs can accept.
This device obtain the last memory function therefore, the device
will use the last output port 1's EDID when output port 1 is not
connected to a display after power cycling or switch in between
the EDID setting.
Switch to STD to use build-in EDID if the display has problem. STD
EDID's video at 1080p@60Hz and audio at LPCM 2CH.
8
SERVICE: This slot is reserved for factory service only.
9
DC 24V: Plug the 24V DC power supply into the unit and connect
the adaptor to an AC outlet.
st
CAT5e/6/7
st
CAT5e/6/7 output is
4