Ashley P324-776 Panduan Pemilik - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Perapian Luar Ruangan Ashley P324-776. Ashley P324-776 18 halaman. Outdoor gas fire pit

Halaman Cetak

CONNECTING AND DISCONNECTING LP & NG

• Connecting LP Gas Tank

Before connecting, be sure that there is no debris

caught in the head of the LP gas tank, head of

the regulator valve or in the head of the burner

and burner ports.

Connect regulator/hose assembly to tank by

turning knob clockwise.

• Disconnecting LP Gas Tank

Before disconnecting make sure the LP gas tank valve

is "CLOSED."

Disconnect regulator/hose assembly from LP gas tank

by turning knob counterclockwise until it is loose.

Caution: LP gas tank must be properly disconnected

and removed prior to moving this pit.

• Connecting NG

1. A professionally-installed shut-off valve between the supply piping and the socket is

recommended, but not required, by the National Fuel Gas Code. Socket connection

must be made outdoors.

2. Coat the gas supply pipe nipple with gas-resistant pipe dope or approved teflon tape. Screw socket onto gas

supply pipe (house gas source), and wrench-tighten.

3. Pull back the sleeve on the quick disconnect socket and insert the unattached end of the gas hose into the

socket. Release the sleeve and continue pushing the hose into the socket until the sleeve snaps into the

locked positon.

4. When the quick disconnect socket and the gas hose are connected, a valve in the socket opens automatically

to permit full gas flow. When the gas hose is disconnected, the valve in the socket instantly and positively

shuts off the flow of gas, the grill can be disconnected from the gas source by disconnecting the gas hose

from the quick disconnect socket. The socket should be left attached to the gas source (hose piping).

• Disconnecting NG

With proper assembly, the gas hose cannot be removed without pushing the quick disconnect sleeve back. To

disconnect, push sleeve back and pull plug out of sleeve (this automatically shuts off gas). The appliance and its

individual shut off valve must be disconnected from the gas supply piping system during any pressure testing on

that system at test pressures in excess of 1/2 psi (3.5kPa).

The appliance must be isolated from the gas supply piping system by closing its individual manual shut off valve

during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psi (3.5kPa).

This appliance can use two types of fuel/gas: LPG-Propane OR Natural Gas

Suitable LP gas tank size for this appliance is 20 lb (9.1 kg)

Do not fill the LP gas tank with more than 80% liquid gas

The inlet gas supply pressure for the purpose of input adjustment pressure:

LPG-Propane 28 cm (11 in) w.c. (2.74kPa)

Natural Gas 18 cm (7 in) w.c. (1.74kPa)

The appliance must be isolated from the gas supply piping system by closing its individual

manual shut off valve during any pressure testing of the gas supply piping system at test

pressures equal to or less than 1/2 psi (3.5kPa).

The LP-gas supply cylinder to be used must be:

•

Constructed and marked in accordance with the U.S. Department of Transportation (D.O.T.)

Specifications for LP-Gas Cylinders;

•

Provided with a listed overfilling prevention device, and provided with a cylinder connection

device compatible with the connection for the appliance.

WARNING: Make sure LP gas tank valve is closed. Close by turning valve clockwise.

Place the LP gas tank upright into the tank tray and secure the tank by screw.

Figure 17, Page 11

LP GAS