Cloud Bose 32 Panduan Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Unit Kontrol Cloud Bose 32. Cloud Bose 32 3 halaman. Two channel equalisation module

Halaman Cetak
1
Bose
1
Models
This Bose
multi-channel amplifiers, and is available in two models:
• Model 8 card for use with Bose
• Model 32 card for use with Bose
Each channel of the Bose
the installers discretion by moving the following links to their ON or OFF
positions. Link 1 and 2 can be found adjacent to the connector marked as
CON1 on the Bose
LK1 controls Channel A
LK2 controls Channel B
2
Installation Information
The Bose
Connectors for the Bose
the unit. They are clearly marked as 'CON1', 'CON2' and 'CON3':
CON 1 = Channel 1&2
CON 2 = Channel 3&4
CON 3 = Channel 5&6 (only on CX-A6)
Compatible Bose
65Hz high pass filters switched 'on' by moving the relevant jumper to the 'IN' position. The
jumpers are clearly marked as J1-6:
J1 = Channel 1, J2 = Channel 2, J3 = Channel 3, J4 = Channel 4, J5* = Channel 5, J6* = Channel 6
* = Jumpers J5 and J6 are only present in the CX-A6.
NOTE: Early versions of the CX-A4 and CX-A6 do not have 65Hz filters, if you are using one of
these earlier models care must be taken to avoid high-level low-frequency input signals.
16-07-02 V2.0
Two Channel Equalisation Module
equalisation module is compatible with the CX-A4 and CX-A6
equalisation module can be turned on or off at
equalisation module PCB.
equalisation module cannot be installed to a channel that has a VCA module fitted.
equalisation modules are located approximately 50mm from the rear of
speakers are of the 100V line type. All equalised channels should have their
CX-A4 Bose
Equalisation Module Connector and 65Hz Filter Locations
CX-A6 Bose
Equalisation Module and 65Hz Filter Connector Locations
Bose
Two Channel Equalisation Module: Installation Guide
Installation Guide
model 8 speakers.
model 25, 32 and 102 speakers.