Cloud Bose 8 Panduan Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Unit Kontrol Cloud Bose 8. Cloud Bose 8 3 halaman. Two channel equalisation module



Bose

Two Channel Equalisation Module: Installation Guide

Installation Instructions

1. Switch off the power and remove the mains lead.

2. Remove the top panel from the unit.

3. Remove both jumpers from the connector(s) you are to use (See previous page for details).

4. Configure the relevant 65Hz filter (See previous page for details).

5. There will be two M3 screws through the PCB, one either side of the connector. Remove these

screws & retain them. In their place screw in the two 25mm M3 hex spacers provided.

6. Connect the Bose

module is in the orientation shown in the diagrams below:

6. Line the holes of the Bose

screws (removed earlier)

7. Replace the top panel.

Telephone +44(0) 114 244 7051 Fax +44(0) 114 242 5462 E-mail: [email protected]

16-07-02 V2



equalisation module onto the relevant PCB connector. Making sure that the

Top Down View of Bose

Ribbon Cable Orientation (Side View)



equalisation module up with the hex spacers and fit the two M3



Bose

is a registered trademark of The Bose Corporation

Cloud Electronics Limited 140 Staniforth Road Sheffield S9 3HF England



Equalisation Module Orientation in a CX-A6

(Same orientation as CX-A4)