Ashly PE Series Panduan Pengoperasian - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Penguat Ashly PE Series. Ashly PE Series 13 halaman. Pe-series amplifier
Juga untuk Ashly PE Series: Panduan Pengoperasian (13 halaman)

Ashly PE Series Panduan Pengoperasian
Operator Manual – PE Series Amplifiers

Spec Table

(
All Specifications Subject to Change or Improvement Without Notice.)
Power Output
Stereo Mode, both channels driven
8 ohms, 20 Hz - 20 kHz, 1% THD
4 ohms, 20 Hz - 20 kHz, 1% THD
2 ohms, 20 Hz - 20 kHz, 1% THD
Bridged Mono Mode
8 ohms, 20 Hz - 20 kHz, 1% THD
4 ohms, 20 Hz - 20 kHz, 1% THD
Parallel Mono Mode
2 ohms, 20 Hz - 20 kHz, 1% THD
Signal to Noise (20 Hz-20 kHz,
unweighted, 26 dB amplifier gain):
Voltage Gain:
Output Circuitry:
Current Draw (both channels driven)
Idle
8 ohms
4 ohms
Power Requirements
*(1/8 Power Pink Noise @ 4 Ohm):
Power Cable Connector
All Models
Distortion (SMPTE, typical) - 8 ohm load,
10 dB below rated power
Distortion (THD+N, typical) - 8 ohm load,
10 dB below rated power, 20 Hz - 10 kHz
Frequency Response
Damping Factor - 8 ohm load, < 1 kHz
Input Impedance
Maximum Input Level:
Cooling
Control Network:
Front Panel Indicators
Attenuators:
Input Connectors, each channel
Output connectors, each channel
Amplifier Protection
Load Protection
Dimensions
Weight (lbs./kg)
Latency (48 kHz/96/kHz)
A/D, D/A Converters:
DSP
Digital Input
DSP Modules Signal Processing
Delay, Compressor/Limiter
EQ:
HPF/LPF:
Signal Generator:
PE-800
PE-1200
200 W
300 W
400 W
600 W
700 W
1,100 W
800 W
1,200 W
1,400 W
2,200 W
800 W
1,200 W
>98 dB
>105 dB
Bipolar, Class AB Bipolar, Class AB
Bipolar, Class H Bipolar, Class H Bipolar, Class H
Typ
Max
Typ
Max
2.4A
2.8A
2.4A
6.6A
13.6A
8.6A
20.2A
8.4A
9.4A
21.8A
13.6A
33.8A
420W
640W
15A Edison
30A Twistlock
onboard, compatible with standard 10 Base-T/100 Base-TX Ethernet hardware
Overall: power, standby, protect, bridged mono, parallel mono, communications
inrush current limitation, temperature monitoring heat-sinks, output DC protection, power transistor SOA protection, output
Optional Protea
NE
Analog Inputs: 1.42ms/.71ms
24-bit, 96-kHz
24-bit conversion with 32-bit, floating-point DSP processing
AES/EBU, 16-24 bit, 48 or kHz.
Graphic and Parametric
Up to 48 dB/octave
Sine Wave, White Noise and Pink Noise
All Rights Reserved
PE-1800
PE-2400
PE-3000
500 W
700 W
900 W
900 W
1,200 W
1,500 W
1,400 W
1,500 W
1,500 W
1,800 W
2,400 W
3,000 W
2,800 W
3,000 W
3,000 W
1,800 W
2,400 W
3,000 W
>108 dB
>110 dB
>111 dB
26 dB, 32 dB or 1.5 V sensitivity (selectable)
Typ
Max
Typ
Max
Typ
2.4A
2.6A
26.2A
10.4A
33A
12.4A
13A
42A
15.8A
54A
19.6A
611W
790W
1010W
30A Twistlock
30A Twistlock
30A Twistlock
temperature dependent speed-controlled axial fan
Per channel: Clip, -6 dB, -12 dB, -18 dB, Temp, Output current.
Per channel: front panel, software, offset and remote
XLR female/TRS, Euroblock, XLR male (looping)
over-current protection, mains fuses protection
19"W x 3.0"H x 13.5"D / 483mmW x 88.9mmH x 340mmD
22 to 24 lbs / 10 to 10.9 kg Net, 27 to 29 lbs / 12.3 to 13.2 kg Shipping
/DSP Input Card
Digital Inputs: .65ms/.32ms
Introduction - 2
The PE Series - 3
Physical Description - 4
PE-3800
Installation – 5
Operation – 7
1,100 W
Troubleshooting - 8
1,900 W
1,500 W
Spec Table - 9
Measurements - 10
3,800 W
Dimensions - 11
3,000 W
Warranty - 12
3,800 W
>112 dB
Bipolar, Class H
Max
Typ
Max
2.8A
42A
14.6A
50A
68A
22.6A
80A
1220W
30A Twistlock
<.01%
<.01%
20 Hz - 20 kHz, +/- 0.15 dB
> 400
20 kOhm, balanced
+21 dBu
Speakon, screw terminals
Adjustable clip limiter
Page - 9