Ashly TM-335 Panduan Pengoperasian - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Penguat Ashly TM-335. Ashly TM-335 12 halaman. Public address mixer/amplifier

Operating Manual - TM-335 Public Address Mixer/Amplifier

Rear Panel Features

1) AC Mains

This is the AC cord for connecting to 120VAC mains, 60Hz, 40W. Certain export models

connect to 230V and are labelled accordingly.

2) Main Speaker Outputs

This 5.08mm Euroblock connector is used for speaker output wiring. For low impedance

speaker loads, connect between the COM and 12V/4Ω terminal or COM and 17V/8Ω terminal. For

25V or 70V distributed speaker applications, connect the speakers between COM and 25V or 70V

terminals, depending on the transformers/speakers used. For distributed speaker loads on 230V

export models, connect between COM and 70V or 100V terminals.

3) CD/Satellite Input

These RCA inputs accept a stereo line level signal and sum them to mono on channel 3 input.

To use the CD/Satellite RCA inputs, be sure to set the channel 3 Select switch (#4 below) to the left.

4) Input Select Switch

This switch selects either the stereo line level input on RCA jacks, or mic level input on the

MIC 3 Euroblock connector.

5) MIC 3 Input

This 3.5mm Euroblock connector is used for MIC 3 input. To use the MIC 3 input, set the

channel 3 SELECT switch (#4 above) to the right. Wire the microphone (+) signal to pin 1, the (-)

signal to pin 2, and (G) to pin 3. If wiring an unbalanced mic input signal into a balanced Euroblock

input, be sure to ground the (-) input pin.

6) MIC 1 Input

This 3.5mm Euroblock connector is used for MIC 1 input. Wire the microphone (+) signal

to pin 1, the (-) signal to pin 2, and (G) to pin 3. If wiring an unbalanced mic input signal into a

balanced Euroblock input, be sure to ground the (-) input pin. MIC 1 input has ducking priority over

MIC 2 and MIC 3 inputs, with an adjustable ducking depth control. There is no phantom power

available on the TM-335.