Cypress EZ-Color CY3263-ColorLock Panduan Memulai Cepat - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Perangkat Keras Komputer Cypress EZ-Color CY3263-ColorLock. Cypress EZ-Color CY3263-ColorLock 12 halaman. Evaluation kit

Halaman Cetak

4. Use the Board as Factory Programmed

The board can be controlled using the Windows ColorLock Monitor application provided on the kit's

CD. This application can be installed on a personal computer running either the Windows XP or Win-

dows Vista operating system. (Note The application might run on earlier versions of Windows, but it

has not be tested for those versions.) See the CY3263-ColorLock EZ-Color Evaluation Kit Guide for

detailed instructions on the CY3263-Color Monitor application.

When using the board with the ColorLock Monitor application, the board must be attached to the

computer using a USB cable (included). The board can be attached to the computer before or after

the application is started. Once the hardware is attached, the status field located on the bottom edge

of the display on the right-hand side indicates that the hardware is present. This status field is dis-

played as green when the hardware is present and red otherwise.

Note The ColorLock Monitor application is completely separate from the Tuner in PSoC Express

and will not function while PSoC Express is open.

Setup the CY3263-ColorLock EZ-Color Kit

4.1.

Power the CY3263-ColorLock EZ-Color device using the provided AC power adapter.

4.2.

Press the On/Off button and notice the viewing window light up then dim to indicate it is on.

4.3.

Press the Color button to cycle through the preset colors.

4.4.

Plug the USB cable into the side of the case and also into the USB port on the PC.

4.5.

If a popup window appears asking to install a driver follow the steps labeled Recommended.

4.6.

Open the ColorLock.exe application

various settings on the CY3263-ColorLock EZ-Color Evaluation board.

4.7.

Ensure the USB Link Status field in the bottom right corner of the window is green and dis-

plays Connected to ColorLock Demonstration. If it does not, recheck all connections to

the board.

(Figure

1-2). This stand alone GUI enables you to adjust