Ashly MX-206 Panduan Pengoperasian - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Mixer Musik Ashly MX-206. Ashly MX-206 9 halaman. Stereo microphone mixer
Juga untuk Ashly MX-206: Panduan Pengoperasian (12 halaman), Catatan Teknis & Spesifikasi (2 halaman), Panduan Pengoperasian (8 halaman), Panduan Pengoperasian (12 halaman)

Operating Manual -MX-206 Stereo Microphone Mixer

4.6 Stereo Outputs

The Left and Right output levels are independently

controlled by these two dials. They respectively determine the

signal at the 1/4" jack Main outputs.

4.7 Mono Output

This inner concentric control determines the output

level of the transformer-balanced Mono Output XLR con-

nector. Its signal is summed from the right and left mix bus,

and is fully independent of the settings of the stereo output

level controls.

4.8 Headphones Output Level

This outer concentric control determines the level of

the stereo headphones, and is fully independent of the settings

of the stereo and mono output level controls

4.9 Output Meters

Two 6-segment LED arrays show the current status of

the stereo outputs. 0VU is equivalent to +4dBu (1.228Vrms).

4.10 Stereo Headphone Jack

You can monitor the stereo mix through headphones

independent of all other output controls. In other words, the

headphones can be used even if all other output controls are

turned off.

4.11 Phantom Power Indicator

This red LED is lit when the +48V phantom power

is turned on. The phantom power switch is on the back panel.

4.12 Power Switch

This switch turns on AC power to the mixer, lighting

the green LED. If the switch is pressed but the LED is still off,

check to see that the AC power cord is not detached.

5. CONNECTIONS AND CABLES

The MX-206 mixer is fitted with five types of audio

connectors: 3-pin XLR type male (mono output), 3-pin XLR

type female (mic inputs), tip-ring-sleeve (TRS) phone jacks,

RCA jack, and 3.5mm stereo TRS jack. Although using unbal-

anced tip-sleeve 1/4" plugs will work in certain applications,

we recommend always using balanced TRS cabling for the

stereo 1/4" jack outputs.