Cypress CE217646 Manual - Halaman 10

Jelajahi secara online atau unduh pdf Manual untuk Penerima Cypress CE217646. Cypress CE217646 20 halaman. Ble wireless power transfer with psoc 6 mcu with ble connectivity

Halaman Cetak
Components and Settings
Table 4
lists the PSoC Creator Components used in Wireless Power Receiver project, how they are used in the design, and the
non-default settings required so they function as intended.
Component
Instance Name
BLE
Bluetooth Low
Energy (BLE)
SW2
Digital Input
Pin
Disconnect_LED
Digital Output
pin
Advertising_LED
Charging_LED
UART_DEBUG
UART (SCB)
Table 5
lists the PSoC Creator Components used in Wireless Power Transmitter project, how they are used in the design, and
the non-default settings required so they function as intended.
Table 5. PSoC Creator Components used in Wireless Power Transmitter project
Component
Instance Name
BLE
Bluetooth Low
Energy (BLE)
SW2
Digital Input
Pin
Scanning_LED
Digital Output
pin
UART_DEBUG
UART (SCB)
For information on the hardware resources used by a Component, see the Component datasheet.
www.cypress.com
Table 4. PSoC Creator Components used in Wireless Power Receiver project
The BLE component configured to the Wireless Power
Transfer profile.
This pin is used to connection the user button (SW2).
These GPIOs are configured as firmware-controlled
digital output pins that control LEDs.
This Component is used to print messages on a terminal
program.
The BLE component configured to the Wireless
Power Transfer profile.
This pin is used to connection the user button
(SW2).
This GPIO is configured as firmware-controlled
digital output pin that control LED.
This Component is used to print messages on a
terminal program.
Document No. 002-17646 Rev.**
BLE Wireless Power Transfer with PSoC 6 MCU with BLE Connectivity
Purpose
Purpose
Non-default Settings
Refer to
Parameter Settings for
Wireless Power Receiver project
[General tab]
Uncheck HW connection
Drive mode: Resistive Pull Up
[General tab]
Uncheck HW connection
Drive mode: Strong Drive
Default
Non-default Settings
Refer to
Parameter Settings for Wireless
Power Transmitter project
[General tab]
Uncheck HW connection
Drive mode: Resistive Pull Up
[General tab]
Uncheck HW connection
Drive mode: Strong Drive
Default
10