AERMEC PCO5 Panduan Pengguna - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Panel Kontrol AERMEC PCO5. AERMEC PCO5 20 halaman.

ALARM MENU

The ALARM menu is used to view (and reset, if necessary) the alarm conditions that

may arise on the unit while it's working. The alarms are divided into various catego-

ries according to their seriousness. Remember that some of them can cause serious

damage to the unit so, before performing a reset, it's important to be sure about the

nature of the alarm and the reason it was triggered (contacting specialised techni-

cal personnel if necessary).

NOTE: The top-left corner of each window shows which compressor is currently

providing the displayed data (U:1,2,3 o 4); to switch between compressors (only

possible from Master unit), refer to that explained in paragraph "3.3 Unit operating

status information (real time data) p. 7".

— Indicates to which compressor the displayed data refers (U:1 = Master; U:2 =

Slave 1; U:3 = Slave 2; U:4 = Slave 3)

— Indicates the number of alarms currently active on the unit.

— Indicates to which compressor the displayed data refers (U:1 = Master; U:2 =

Slave 1; U:3 = Slave 2; U:4 = Slave 3)

— Indicates the alarms currently active on the unit providing some information on

the nature of the alarm

— Indicates to which compressor the displayed data refers (U:1 = Master; U:2 =

Slave 1; U:3 = Slave 2; U:4 = Slave 3)

— Indicates the time and date when the alarm was triggered

— Indicates the alarm ID code

— Indicates the short description of the alarm

— Indicates the temperature of the water entering the heat exchanger at the time

of the alarm

— Indicates the temperature of the water leaving the heat exchanger at the time

of the alarm

— Indicates the high pressure at the time of the alarm

— Indicates the low pressure at the time of the alarm

— Indicates the temperature on the pressing line at the time of the alarm

— Indicates the setpoint value at the time of the alarm

— Indicates the differential value at the time of the alarm

— Indicates the anti-freeze setpoint value at the time of the alarm

1. Used to go to the first alarm in the alarm log

2. Used to go back to the previous alarm in the alarm log

3. Used to move on to the next alarm in the alarm log