Cypress Semiconductor FM4-U120-9B560 Panduan Memulai Cepat - Halaman 11
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Motherboard Cypress Semiconductor FM4-U120-9B560. Cypress Semiconductor FM4-U120-9B560 13 halaman.
Halaman Cetak
6.
To run the UART test (CMSIS-DAP Com Port) the USB cable needs to be connected at CN3. Open jumper J9 and
close jumper J7. Repeat steps 1 through 4 to connect the virtual communication port created by CMSIS-DAP
firmware to the Cypress Serial Port Viewer and Terminal.
7.
Once the terminal is connected, press the space bar on PC keyboard and the welcome message will display. The
space bar is used as the input for the UART test.
8.
If any issues or failures are encountered, ensure all jumpers are in default position as listed in
FM4-U120-9B560 Quick Start Guide, Doc. No. 002-05534 Rev. *A
Run PCB Board Test Demonstration
Figure
4-1.
10