Cyron AF106AD Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Pencahayaan Cyron AF106AD. Cyron AF106AD 4 halaman. Auxiliary light

Secure the light in place. Do not tighten the adjustment screws until the lights

have been aligned.

Secure the wires with zip ties. If mounted to lower forks or other moving parts

avoid leaving too much loose wires which could fray or get caught to other

objects. Leave just enough to clear the max extension of the moving parts.

Align the light. For proper operation it is vital to check the aim of the light. Use the

diagram below as a starting guide.

NOTE: For low beam applications the goal is to keep the light on the road as far

forward as possible without disturbing the oncoming traffic.

During testing make sure:

a. The vehicle is on level surface

b. There are no excessive loads in the vehicle affecting its leveling

c. For motorcycles it is a good idea to align with the rider on the bike

d. After alignment do a road test to assure proper visibility has been achieved.

Further adjustment may be necessary to get the optimum performance.

Tighten all the screws.

HINT: Check the alignment of the light again after a few hours on the road. To

facilitate mark the position of the light beam on garage wall after the initial

alignment. Compare at a later point to make sure the lights have remained

aligned.