CyronMotor ABS1LHC Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Pencahayaan CyronMotor ABS1LHC. CyronMotor ABS1LHC 8 halaman. Auxiliary light

Figure 1

NOTE: ABS1L may only be available as a combo set in ABS1LHC.

INSTALLATION

As an overall plan we recommend on deciding the approximate location of the lights first.

Do wiring per instructions below and have the wire plugs reach the mounting area. Then

securely mount the light. Plug the lights to the power cords. Finally tighten up the wires and

cords.

The installation varies depending the light and how you wish to control it.

Controlling Option A – Ignition: Connection to an ignition-controlled wire. This will turn on

the lights every time ignition is turned on. Use an inline fuse if the supply wire is not fused.

Fuse rating must be 5A for each ABS1 installed. ie. Two ABS1 require a 10A fuse.

Controlling Option B – Headlight: Direct connection to headlight wire harness.

Connected to low beam or high beam will turn on the ABS1 at the same time as the

headlight. Whether you choose low beam or high beam depends if you are intending to

improve low beam or high beam visibility. On some vehicles/bikes low beam stays on all

the time therefore if connected to low beam the aux lights will remain on all the time.

IMPORTANT: For each ABS1 4A or approximately 50W of power will be drawn. Consult

with your vehicle manufacturer specifications if this additional power can be handled by the

headlight harness. Never exceed the ratings.

SUGGESTION: First step in upgrading your night time visibility should be converting

low/high beam bulbs to LED technology. Most LEDs have a lower power draw than stock

lights which will free up some power draw from your factory harness. ie. if you replaced a