Cyrus Cyrus Quattro Petunjuk Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Sistem stereo Cyrus Cyrus Quattro. Cyrus Cyrus Quattro 7 halaman. Hi-fi products

Halaman Cetak

User Instructions

OPERATION

Key to the front panel drawing (Fig 2):

13. CD Loading Tray

14. Standby Key

15. Standby Light

16. Remote Eye

17. Display Window

18. Stop/Open

Switching On

The mains power to the Quattro should normally be left on unless left

unattended for a long period when the mains power at the wall socket should

be switched off or the product disconnected from the AC supply.

When power is applied, the front panel STANDBY key 1$ is used for power

control. The Standby light 1% shows red when the Quattro is in Standby and

green when operational.

Listening to a CD

Selecting CD input

Select the CD input with the front panel Input key 2!.

Loading a CD

Press the STOP/OPEN key 1* to open the CD tray. Place a CD in the tray

with the label side upward. Press the STOP/OPEN key 1* again. The CD tray

will load into the player. The Quattro display will show 'Reading...' while

checking the contents of the disc.

Volume control

The volume level is controlled from the front panel with the Volume up/down

keys 1(,2). The display will switch briefly to show the volume level setting (Fig

4e).

Selecting a track

Press the Scan keys 2@,2# briefly to move forward or backward through the

tracks on the CD. Track indications 3% appear on the display (Fig 4a).

Pausing

Press the Play/Pause key 2$ to pause the current track. The disc will be held

at the point of interruption and the Pause symbol 3* will show on the display

(Fig 4b). Press the Play/Pause key 2$ again to resume playing the disc.

Fast Forward/Reverse Search

You can search forward or backward to locate a specific point within a track

by holding down the scan keys 2@,2#. The search will commence initially at a

slow speed increasing after a few seconds if the key is held down.

Stopping the disc

When a disc is playing, press the Stop/Open Key 1* once to stop the disc

immediately.

If the disc is already stationary, one touch of the Stop/Open key 1* will open

the tray.

Listening to Radio (only with tuner module fitted)

Selecting Tuner input

Select the TUNER input with the front panel Input key 2!.

Searching for a station

Press one of the Scan keys 2@,2# to search for a station. When a station is

found the station name will be shown on the display (Fig 4d). If the station

does not broadcast name data, the station frequency 4) will be shown (Fig

4c).

Volume control

The volume level is controlled from the front panel with the Volume up/down

keys 1(,2).

Listening to an External Source (Aux/Tape)

Selecting Aux or Tape input

Select the correct input with the front panel Input key 2!.

Volume control

The volume level is controlled from the front panel with the Volume up/down

keys 1(,2).

19.

Volume up

20.

Volume down

21.

Input Select

22.

Next Track

23.

Previous Track

24.

Play/Pause

Making Recordings

Selecting the source to record

Select the required source for recording with the front panel Input key 2!, then

set the Tape Recorder to 'Record'.

CAUTION:- Do not select the TAPE input whilst making a recording from the

Quattro, a loud noise may occur due to feedback in the tape recorder.

Record level setting

Record level (where necessary) should be set at the recorder. The volume

control of the Quattro will not affect the record level.

Digital recordings

High quality digital recordings may be easily made from the Quattro CD player

to a Digital Tape or Disc Recorder connected to the Quattro CD digital output.

No adjustment is necessary to the Quattro once the CD player is set to play.

Listening through headphones

The Quattro is equipped with a standard ¼" (6.35mm) headphone connector

1@, located on the rear panel.

When headphones are connected to the Quattro for personal listening the

sound from the system speakers will automatically be muted.

REMOTE CONTROL

Key to the remote control drawing (Fig 3):

25. Standby

26. Mute

27. Input select

28. Change track

29. Stop

All front panel controls of the Cyrus Quattro feature on the remote handset.

The remote control handset also provides access to some additional features

of the Cyrus Quattro.

Input source selection

The Input Source keys 2& enable direct access to each of the four available

input sources.

Volume control

The Volume control keys 3$ enable remote setting of volume levels.

Mute

The Mute key 2^ will temporarily reduce the volume level to zero. Press the

Mute key 2^ again to restore the previous volume setting.

CD operation keys

When a CD is playing the remote control includes keys for Track Selection 2*,

Stop 2(, Fast Forward/Reverse Search 3) and Play/pause 3#.

Tracks can be selected directly with the numbers of the Numeric Keypad 3!. If

the disc playing has more than 10 tracks, the Quattro will pause briefly

awaiting for the entry of a second digit where appropriate.

Tuner operation keys

When listening to the tuner, the remote control includes keys which will Step

through the presets 2* or Search the band for a station 3).

When presets stations have been stored in the memory (see next section),

they can be selected directly with the numbers of the Numeric Keypad 3!. As

each preset is selected, the display will briefly show the station number 3( and

frequency 4) before displaying the station name (where available).

Storing preset radio stations

For convenience the Quattro has nine preset memories (1-9) in which stations

can be stored for quick access.

To store a station, follow this sequence-

Tune to a station with the Search keys 3).

Press the Store key 3@. The display will read 'Store...'.

From the Numeric Keypad 3!, press a key (1-9) for your chosen preset

number and the station will be stored for later recall.

Repeat the sequence to store your other favourite radio stations.

Cyrus Quattro

30.

Search forward/reverse

31.

Numeric keypad

32.

Store

33.

Play/pause

34.

Volume