Cytech KP04 Panduan Instalasi - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Papan tombol Cytech KP04. Cytech KP04 20 halaman. Lcd keypad
Juga untuk Cytech KP04: Panduan Memulai Cepat (4 halaman)

Halaman Cetak

KP04 LCD Keypad Installation Manual

Arm (Red)

Steady

Blinking

AC (Red)

Steady

Blinking

Msg (Green)

Steady

Blinking

Mic (Red)

Steady

Blinking

Installation

The keypad should be installed in an indoor location. It should not be

located outside the premises for security reasons.

Open the Keypad housing by unscrewing the screw at the base.

Mount the back housing on the wall using the screws supplied. The

KP04 can replace the KP01 or KP02 with little difficulty as the

position and size of the mounting holes are identical to that of the

older products.

Connect the 6 wires from the terminal blocks (JP1, JP2 and JP3) on

the Keypad to the Comfort PCB according to the signal name. Note

that the 12V should be connected to the 12V terminal on Comfort

and not the S12V terminal.

4. If you are replacing an existing KP01/KP02, note that the

pairs of wires KA/KB, 12V/COM, Mic/Voice are reversed on

the connectors. This is to comply with the orientation used in

all other Comfort modules, e.g. UCM, Comfort, which is

different from that used in the KP01/KP02

If more than one Keypad/Door Station is used, connect their 12V and

ground wires back to Comfort control panel individually. Do not

connect them in series as this may result in excessive voltage

drop along the cable.

Set the shunts for each of the ID of the keypad correctly (SW1).

They must be numbered consecutively, i.e. if there are 2 Keypads,

one should be set to ID 1, and the other as ID 2. The IDs for the

Keypads and Door Stations are independent.

Set the correct number of Keypads either using Comfigurator (or

using the keypad via location 1675). The default is set to 1 keypad.

Reset Comfort after changing the value.

System in arm mode, all conditions normal (no alarm

conditions present). The security mode (Away, Night, Day,

Vacation) is displayed.

Alarm / alert condition.

Mains Power failure.

Standby battery voltage is low. The battery should be

replaced.

New memo from user. Press # to hear who the message is

for. Sign in on keypad with user code to hear the message

New memo from user. Press # to hear who the message is

for. Sign in on keypad with user code to hear the message

Microphone is on for Recording or Intercom

N.A.