Ask IMPRESSION A10+ Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Proyektor Ask IMPRESSION A10+. Ask IMPRESSION A10+ 8 halaman. Flash upgrade user guide

FLASH UPGRADE USER GUIDE

6. SENDING THE FILE (SW&HW)

1. Flashing the SW EPROM: Type RRP;38400 and press Enter.

2. Flashing the HW EPROM: Type FPG;38400 and press Enter.

It is not necessary to use capital letters, but the command must be written exactly as

described, otherwise the projector will return "Undefined Command..". This will also happen if

you type incorrectly or try to erase text.

3. On "Hyperterminal", close the connection by clicking on the "hang up phone icon".

4. Go into "File | Properties" and press "Configure".

Use the ADVANCED /SERVICE / INFO dialog-box on the projector to make sure that the

settings match those of the computer. Change the settings as described below. Confirm

with OK two times to close the dialog boxes.

Re-establish the connection to the projector, so that the status bar in the lower left corner

reads "Connected".

7. Open the transfer menu and select "Send File..."

8. Browse so that the correct BIN file, which can be found on the Proxima web page under

"MLS resources Firmware.., can be selected and inserted in the file name field. It will be

explained on the web page which BIN file (HW or SW) requires the different RS232

commands (RRP or FPG). Both the SW bin and the HW bin file are 805.xxx#.bin files.

9. Set protocol to Xmodem as described in figure below. Filename should read the name of

the BIN file you have selected.

PROXIMA ASA

"Bits per second"

"Data bits"

"Parity"

"Stop Bits"

"Flow control"

IMPRESSION A10+/A9+/A8+

38400 Baud

8 bit

None

1 bit

None