EG Bali 500EX Panduan Pemilik - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sepeda EG Bali 500EX. EG Bali 500EX 8 halaman.

INSTALLATION INSTRUCTIONS

1. Unpack the bicycle from the box and cut all the ties that held the bicycle together during

shipping.

Install the handle bar by inserting the handlebar stem onto the head tube. Tighten the

handlebar stem screw with an Allen key.

Adjust the handlebar by loosening the nut holding the handlebar and then re-tightening it with

an allen key.

4. ! WARNING: Do NOT over tighten nut against the fork; for you will risk damaging your

suspension fork.

The front LED/reflector Lamp runs on the main bicycle battery while the rear LED lamp runs on

regular AAA batteries. The Front LED is turned on/off by holding the "+" button after the system

is turned on. The rear LED lamp switch on top of the rear LED. Remove the plastic tab on the

battery to start using the rear LED. The rear LED is supplied in the accessory box.

Install the pedals to the bike. Each of the pedals has a letter indicating which side it needs to

be installed to. R=Right and L=Left. Install them using a Metric size 15 wrench.

! WARNING: Before riding the bicycle ensure the main Li-on battery has been fully charged, is

properly installed and locked in. If the Battery is not firmly locked into the frame tube. it may

slide out and cause damage to the battery.

Insert the battery into the battery holder by aligning the bottom of the battery and then lock the

battery in flush with the frame of the bike. To ensure that the battery is locked in, lightly tug on

the battery handle outward to ensure it come unlatched.