BlueParrott C300-XT Panduan Pengguna - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Headset BlueParrott C300-XT. BlueParrott C300-XT 20 halaman.
Juga untuk BlueParrott C300-XT: Memulai (13 halaman), Memulai (13 halaman)

Halaman Cetak
BlueParrott C300-XT Panduan Pengguna

GETTING STARTED

On/Off/Standby

Turn Headset On: Hold down the MFB for approximately 2-3 seconds until you hear
a voice prompt, "power on . " The red LED will flash once every second .
Turn Headset Off: Hold down the MFB for approximately 4–5 seconds until you
hear a voice notification "power off . " A red LED will flash 4 times and the headset
will turn off .
Standby Mode: Once the headset is turned on (after the initial pairing), it will
attempt to connect to the last device that it was paired with, putting itself into
Standby Mode .

Pairing with a Phone

When you turn your C300-XT on for the first
time, or if its Paired Device List has been cleared,
it will go into pairing mode automatically . You
can pair the headset using NFC or manually .
NFC (One-Touch) Pairing
1 . Make sure that NFC is enabled on your cell
phone .
2 . Place the NFC zone of your cell phone against
the NFC zone of the headset and hold them
together until your cell phone registers the
headset .
3 . Follow the prompts on your cell phone to
complete pairing .
Note: NFC and One-Touch Pairing are dependent
on your cell phone. The size and sensitivity of your
phone's NFC zone and the specific way to connect
the headset may vary between devices.
BlueParrott C300-XT User Manual
NFC Zone
PAGE 11