Bluerock Tools CG-30 Panduan Operasional - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Operasional untuk Senter Bluerock Tools CG-30. Bluerock Tools CG-30 18 halaman. Track torch / burner machine

Halaman Cetak
C G - 3 0
T R A C K
T O R C H
o
Ø There are 5 major components located on the machine control panel (see figure below -the white
words indicate the control panel components).
Ø The power cord connection point is where the black power cord plugs in.
o
Ø The machine has a forward/reverse switch located on the main control panel.
o
o
Ø When the directional toggle has been activated, the start/stop lever will manually engage the
gearing to start machine movement.
o
Ø The variable speed switch will increase of decrease the machine speed. 0 symbolizing no
movement and 10 symbolizing fast movement.
Ø The electrical fuse contains a fuse controlling the control board.
o
B U R N E R
M A C H I N E
The side knob will adjust the torch holder up or down.
NOTE: Make sure to line up the half round notch in plug with the half round piece in the
plug input.
This directional toggle switch has arrows pointing in the direction the machine will
travel.
NOTE: There is also a neutral position for this switch in between the positions.
This lever should be in the "STOP" position if not moving. Turn the "START" position to
engage the movement.
CAUTION: Do not remove the fuse unless the machine is disconnected from power
source.
6