Bluerock Tools CG-211Y Panduan Operasional - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Operasional untuk Sistem Pengelasan Bluerock Tools CG-211Y. Bluerock Tools CG-211Y 16 halaman. Pipe torch/burner machine

Halaman Cetak

C G - 2 1 1 Y

T O R C H

Troubleshooting

SERVICING SHOULD ONLY BE DONE BY A QUALIFIED TECHNICIAN.

Problem

Leak gas

1. The torch holder inlet is damaged.

and/or flame in

2. There is copper burr or materials on the

the joint of

surface of the torch tip.

torch and

torch cutting

tip.

The flame

The cutting oxygen leaked into the preheating

goes out as

oxygen area.

soon as the

1. Copper stain or useless materials on the inner

oxygen valve

part of torch

is opened

2. The smaller cone of torch cutting mouth was

stuck with some with material or was damaged.

The steel can't

1. The torch cutting-tip is too small.

be cut through

2. The flame frequency is not strong enough

3. Low pressure for cutting oxygen

4. The hole channel of cutting mouth may be

jammed

5. The cutting oxygen is not pure.

6. The cutting oxygen was leaked into the

preheating oxygen hole channel.

The cutting is

1. The steel pipe was deformed.

not straight

2. The flame line was not straight.

enough.

3. Uneven pipe surface

4. The torch was poorly fixed and can be moved.

5. The chain is not straight

The clutch will

1. The clutch carriage is damaged

not engage.

2. The clutch is dirty

B U R N E R

M A C H I N E

Cause

Note

1. Softly grind the torch cone with small sand paper to clean

out the burr.

2. Clean the material on the cutting tip. Softly grind the

surface with small sand paper. Change the cutting tip if it is

badly damaged.

1. Softly grind the most inner part of torch holder with sand

paper to clean out the debris or damage.

2. Softly grind the smaller surface of the cutting mouth.

Change the cutting mouth if it is serious damaged.

1. Choose the cutting tip spec according to the cutting

thickness.

2. Increase flame frequency properly.

3. Properly increase the cutting oxygen to ensure the enough

flow speed of cutting oxygen.

4. Clean the useless materials in the torch cutting mouth with

cutting pin.

5. Use oxygen with more than 95% purity.

6. Clean the useless materials on the cutting mouth and

torch, repair the damaged surface and change cutting mouth

if needed.

1. Use round steel and calibrate it before cutting.

2. The torch should have a 90

fixed. Clean the useless materials in the torch cutting mouth

with cutting pin.

3. Fix surface irregularities.

4. Tighten all connections.

5. Straighten the chain.

1. Repair or replace the carriage

2. Lubricate the clutch and ensure it moves freely

Chapter

Solution

angle with the steel and tightly