d&b audiotechnik SL Z5731 Panduan Tali-temali - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Tali-temali untuk Sistem Pembicara d&b audiotechnik SL Z5731. d&b audiotechnik SL Z5731 11 halaman. Stacking frame
Juga untuk d&b audiotechnik SL Z5731: Panduan Tali-temali (11 halaman)
Halaman Cetak
2
Assembly/Disassembly
Cabinet Splay links:
KSL-TOP | KSLi-TOP
d&b Z5731 Rigging manual 1.1 en
2.1 Operational safety
The assembly should always be carried out by two persons.
During assembly pay attention to the possible risk of crushing.
Wear suitable protective clothing.
Observe all instructions given on the respective instruction labels of
the rigging components and loudspeaker cabinets.
2.2 Tension mode rigging
NOTICE!
For safety and stability reasons, KSL-TOP cabinets must always be
interconnected using the Tension mode.
KSLi-TOP cabinets are interconnected in Tension mode by default
due to the construction of the cabinet's Splay link.
Note: Please also refer to the d&b SL-Series Rigging manual
which can be downloaded from the d&b website at
www.dbaudio.com.
2.3 First cabinet to frame - Instruction label
The rear center Splay link slot of the frame allows the first cabinet
to be set to downtilt angles from 0° to –10° in 2° increments.
To attach the first cabinet to the frame, proceed as follows:
1. Place the frame into its operating position.
2. Secure the frame against movement and possible tipping over
using appropriate ratchet straps.
3. Release the Locking pins at the front of the frame on both
sides.
4. Attach the first cabinet to the front support of the frame and
reinsert the Locking pins on both sides.
5. Slightly lift the back of the cabinet and release the Locking pin
[3] holding the Splay link in its park position (Þ
6. Fold down the Splay link and insert Locking pin [3] into the
Tension mode hole at the bottom of the rigging strand (Þ
Assembly/Disassembly
).
).
5