AMBIC OptiFlow Panduan Petunjuk Pengoperasian - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Penyemprot Cat AMBIC OptiFlow. AMBIC OptiFlow 13 halaman.

Ambic Equipment Ltd - OptiFlow™ Operating Instructions

The OptiFlow™ Teat Dipping System is designed exclusively for use in milking installations. Any application

outside the use described in this operating manual will be taken to be not in accordance with the intended

purpose. The manufacturer/supplier will not be held responsible for any losses arising as a result of such use.

The user will take full responsibility for use. USE IN ACCORDANCE WITH THE INTENDED PURPOSE ALSO

INCLUDES COMPLYING WITH THE OPERATING MANUAL AND THE CONDITIONS FOR INSPECTION AND

MAINTENANCE.

OptiFlow™ is suitable for use with most dipping chemicals, EXCEPT those containing Hypochlorite. When

diluting concentrated chemical, ensure that the chemical manufacturer's instructions are followed precisely.

ATTENTION! Whilst in operation the installation is under an operating pressure of up to 5 bar!

Do NOT direct chemical into your eyes! If chemical enters eyes, rinse with copious amounts of

water and seek medical attention!

INSTALLATION

PUMP PORTS ASSEMBLY

Remove the nuts, blanking plugs and O-rings from the pump ports, located on the right side of the Power

Unit (A). Connect the Inlet Elbow (B) and the Outlet Tee (C) as shown. Tighten the nut firmly with fingers

or an AmbiSpanner™ – do not use pliers or other tools. This method should be used when connecting all

such fittings on OptiFlow™.

PUMP MOUNTING (Fig. 1)

For general parlour layout refer to Figure 1. Mount the Power Unit (A) on a stable, vertical wall not more

than 3 metres (10ft) above the base of the Chemical Container (D) and close to a regulated Vacuum Line

(E). Ideally it should be mounted in a dust free environment. Do not install above or near to electrical

sockets. The unit will slot onto existing wall brackets where applicable. If this is a new system, fix using 2 x

screws and rawlplugs. Using the drilling template on page 12. Fit one screw first, then carefully mark and

drill the other. Accuracy between centres is most important.

VACUUM SUPPLY

Drill a 10mmØ (3/8"Ø) hole in the top of the regulated main vacuum line (Fig. 3). Remove burrs, lubricate

pipe adaptor (F) and twist into hole. Secure the PVC Tube (G) with Cable Ties (H). Do not over-tighten and

avoid sharp bends. Cut tube to correct length and push firmly onto the Vacuum Tap (I).

CHEMICAL INTAKE

Cut the ½" OD tube (J) to the correct length ensuring that the Intake Filter

the Chemical Container (D). Note that two lengths of Stiffener (L) are supplied, depending on the size of

the container, to ensure the filter stays at the bottom. Ensure that the tubing can be removed from the

container without damaging the tube. The minimum bend radius for the ½" OD tubing is 63.5mm (2.5").

The intake line must enter the Inlet Elbow (B) vertically as shown. Use a clip (M) to secure the tubing

against the wall.

SAFETY

(Fig. 2)

(Fig. 1, 2, 3)

(Fig. 1, 2)

-5-

(K) rests on the bottom of

OFL7500E v1.2 (03/11/21)