Asko HW-19 JR Panduan Memulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Pengering Asko HW-19 JR. Asko HW-19 JR 2 halaman.

QUICK START PROCEDURES

Press the Power button to turn on the machine.

Load the laundry into the dryer.

Check the lint filter. Clean it, if needed.

Check that the door is clear of laundry then close it firmly. (The door won't shut if it's slammed.)

Turn the Timer Control knob to the desired drying time.

Turn the Temperature Control knob to the desired setting.

Make your program option selections (e.g., Anti-crease).

Press Start. The machine will start.

CLEANING THE LINT FILTER

Although the lint in your ASKO dryer will be minimal, the lint filter should be cleaned after each

load to ensure maximum air flow and prevent possible overheating. To clean the filter, follow the

steps below:

1. Grasp the handle and pull it toward you.

2. Remove the filter from the holder by pulling it up.

3. Open the filter and gently brush away any lint.

4. Fold the filter together and return it to the holder on the door.

5. Push the holder in until it snaps into place.

NOTE:

We recommend that you clean the lint filter after every load.

EMPTYING THE CONDENSATION WATER CONTAINER

If the dryer is not installed to pump out the condensed water into a drain or sink, you should empty the

water container every three to five dryer loads, depending on the spin speed you use when you wash the

clothes. For example, clothes spun at 800 rpm will have more moisture when you take them out of the

washer than clothes spun at 1400 rpm. Therefore, the dryer will have to remove more water.

To empty the container, simply pull it out and pour out the water. This water is clean and can be used to

water plants.

If the container becomes too full, the machine will shut down. To restart the program, empty the container

and press Start. It may be a few minutes before the machine starts because it drains the excess water

from the sump before it restarts.

Do not remove the water container while the machine is running.

NOTE:

OVERHEATING PROTECTION

The dryer has a protection device that shuts the machine off if the temperature becomes too high. Overheating could occur if the lint filter is

clogged or the fan or condenser unit needs to be cleaned. If the dryer shuts off during a program, first make sure the condensation water

container is empty. If that isn't the problem, check the lint filter. Lastly, it could be the fan or the condenser unit needs to be cleaned. See your

Use and Care Guide for instructions on how to clean these items.

T720

Simply pull out the container

and pour out the water.