Asko WM25 Panduan Servis - Halaman 11
Jelajahi secara online atau unduh pdf Panduan Servis untuk Mesin cuci Asko WM25. Asko WM25 16 halaman.
Juga untuk Asko WM25: Panduan Servis (20 halaman), Panduan Servis (16 halaman)
Halaman Cetak
Components and measurement values
Item number
Component
80 655 63
Motor 50 Hz
80 637 33
Motor 60 Hz
80 617 06
Heating Element
2000 W
80 761 02
Thermistor
88 012 63.
Drain pump 50 Hz
88 012 64.
Drain pump 60 Hz
80 782 21
Level Switch
80 616 64
Pressure sensor
80 762 02
EMC filter with inductor
50/60 Hz
80 762 01
Inlet valve
80 616 79
Door lock
80 771 27
Control Unit WM25.1
80 771 28
Control Unit WM25.2
80 771 29
Control Unit WM25.3
Measurement value
Resistances:
Pin 2-3 stator 1.41 Ω
Pin 1-3 stator 0.57 Ω
Pin 4-5 rotor 1.54 Ω
(measured diagonally
across the collector)
Pin 6-7 tacho 135 Ω
Resistances:
Pin 2-3 stator 1.05 Ω
Pin 1-3 stator 0.58 Ω
Pin 4-5 rotor 1.75 Ω
(measured diagonally
across the collector)
Pin 6-7 tacho 135 Ω
28.4 Ω
6.1-3.8 k
Ω (at room temperature
20 – 30°C)
144 Ω.
76 Ω
0.5 V out from the
sensor (at 0 bar pressure
and 230 V mains vol-
tage, measurement car-
ried out with the drain
pump running to ensure
0 level is reached)
3,7 kΩ ± 0.5 kΩ
122 Ω
Comments
All resistance values have tolerances of
±8 %.
All resistance values have tolerances of
±8 %.
The thermistor for temperature reading
is located between the motor cradle and
the container. The thermistor measures
and controls the water temperature that
can vary from 0 to 90°C. The element is
disconnected if the thermistor is short-
circuited or disconnected from the
programme control card.
The drain pump is combined with an
integrated fine filter trap, which can be
cleaned by the user. If the drain pump
has run for 180 seconds during drain-
ing, the programme stops, resets and a
trouble code is indicated in the display
(on machines without a display, the LEDs
flash).
See above.
Electro mechanical level switch with
two levels, see wiring diagram. Indicates
levels for door opening, heat and overfil-
ling.
ASKO level sensor type 1166. Controls
intake and level
The filter eliminates interference to and
from the machine.
3 way inlet valve 10 litres / minute
The door lock is electro mechanical and
equipped with a magnet.
Service manual WM25
11