Ambient Technologies TSMT Panduan Petunjuk Pengoperasian - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Pengatur waktu Ambient Technologies TSMT. Ambient Technologies TSMT 9 halaman. Touch screen manual timer

Halaman Cetak
To install batteries,
1. Press down the battery door tab and pull out to remove the battery door.
2. Install the batteries as indicated inside the battery compartments.
3. Close the battery door by snapping in place.
4. When all four batteries are installed, the transmitter will initialize for 5 seconds and then is ready for use.
5. The batteries should be replaced every 12 months or when the low battery icon indicator is displayed.
Changing Temperature Unit
When batteries are installed in the transmitter,
1. all available icons on the LCD will be turned on then be cleared.
2. the LCD will display temperature unit: °F. Use ON ∆ to toggle the units between °F and °C within the first 5 seconds.
3. the transmitter enters Manual Mode
4. the LCD displays room temperature with the chosen unit.
Setting Privacy Code on Transmitter and Receiver:
The remote transmitter privacy code and receiver privacy (DIP) switches are preset in factory. In
the event of activation or interference from other nearby transmissions, change the code using the
following procedures:
1. Press the ON/arrow button and the TIMER button at the same time to enter privacy code setup
f i r e - p a r t s . c o m
mode.
2. The setup display is shown in the figure. The four digits on the top stand for the privacy code (as
the actual DIP switches on Ambient's previous remotes). The default values of the four digits will
be all "1" (ON).
3. The first digit will be flashing upon entering the setup mode. Push the ON button to toggle its
value between "0" (OFF) and "1"(ON), and push the OFF button to jump to the next digit. The
next digit will then start flashing and the first one stops flashing. Set up the four digits to your
choice.
4. After setting up all the four digits, push OFF key to finish the process and return to the previous
mode.
The DIP switches on the receiver need to be changed accordingly after changing the
code on the transmitter:
1. Slide the code switches on the receiver up or down to match the four ON or OFF positions on the
transmitter. Switches #1, #2, #3 and #4 are preset to "ON" for receiver.
2. To check, touch either the On or Off button on the transmitter and the receiver indicator light will
blink. If not repeat step 1.
3. The system is now ready to operate. See optional 6 hour shutdown on receiver section.
On Transmitter Display
20300538
Dip Switch
(Default)
Default Setting
Touch Screen Transmitter Manual Timer Instructions
Receiver
ON
DIP
FP2609

dip switches

FP2608

Privacy code

ON
DIP
Page: