Ambient Weather TESA WS710 Buku Petunjuk - Halaman 7
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Stasiun Cuaca Ambient Weather TESA WS710. Ambient Weather TESA WS710 14 halaman. Wireless indoor/outdoor 8-channel thermo-hygrometer with daily min/max display
Halaman Cetak3. Temperature, Rate of Change indicator
4. Temperature units (°F or °C)
5. Humidity, Rate of Change indicator
6. Relative Humidity (%)
7. Humidity Comfort Icon
8. Reception Icon (solid when searching, flashes when updating)
9. Channel 1,2,3,4,5,6,7,8,
2.4.2 Sensor Operation Verification
Verify the indoor and outdoor humidity match closely with the console
and sensor array in the same location (about 1.5 to 3 meters apart).
The sensors should be within 10% (the accuracy is ± 5%). Allow about
30 minutes for both sensors to stabilize. The humidity can be adjusted
or calibrated later to match each other a known source.
Verify the indoor and outdoor temperature match closely with the
console and sensor array in the same location (about 1.5 to 3 meters
apart). The sensors should be within 2°C (the accuracy is ± 1°C). Allow
about 30 minutes for both sensors to stabilize. The temperature can be
adjusted or calibrated later to match each other or a known source.
3. Remote Sensor Installation
It is recommended you mount the remote sensor on a south facing
wall, in a shaded area. Direct sunlight and radiant heat sources will
result in inaccurate temperature readings. Although the sensor is water
resistant, it is best to mount in a well protected area, such as under an
eve. Use a screw or nail (not included) to affix the remote sensor to the
wall, as shown in Figure 6.
indicator
Figure 6
-7-