Ambirad Apollo QHL 45-3 Buku Petunjuk - Halaman 16

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pemanas Ambirad Apollo QHL 45-3. Ambirad Apollo QHL 45-3 20 halaman. Quartz glow instant infra-red heaters

Halaman Cetak

4.3 Sorrento Range:

1. Ensure the heater and lamp are cool and the

power supply is disconnected by removing the

plugs from the socket outlet - both plugs must

be removed even if only one lamp is to be

replaced.

2. Remove the screws from the terminal box at

the back of the lamp you wish to replace and lift

off the lid - see below.

3. Disconnect the lamp from the connector

blocks by unscrewing the screws highlighted

above below and remove the white coloured

lamp wires from the terminal block.

4. At the back of the heater, remove the plate

holding the terminal box by removing the two

fixing screws as shown below.

5. Pull the lamp wires one at a time through the

plate to remove as shown below.

6. At the front of the heater, the guard in front of

the lamp you are replacing should be removed

by gently pulling it away from the heater so it

prises out of its locating holes at each end.

Remove

the

screw from the side

reflector and lift it up

away

from

the

heater to remove it.

8. Remove the

screws from both

sides

the

middle

reflector

and lift it up to

remove it.

9. The lamp can be

released from the

middle lamp holder

by prising back the

spring

clip

and

lifting up enough to

clear the released

clip as shown.

10. At the opposite end of the lamp the wire

should be pulled out of the side slot and the

lamp can be

lifted

completely

The

wires

should

gently pulled

so they come

out

from

behind

the

reflector.