ACR Electronics FPR-10 PROGRAMMER Manuale di supporto al prodotto - Pagina 8

Sfoglia online o scarica il pdf Manuale di supporto al prodotto per Accessories ACR Electronics FPR-10 PROGRAMMER. ACR Electronics FPR-10 PROGRAMMER 15. Field programmer reader

Stampa la pagina

4. Choose the Country you wish to program into the beacon by either typing the

name of the Country or scrolling to the Country. Once you have selected the

Country, press Enter or double click the mouse on the desired Country.

5. From the Protocol Selection Menu, click on the appropriate protocol.

6. When prompted, enter the value corresponding to the protocol chosen, e.g. if

Serial protocol is chosen, enter the appropriate serial number.

7. The message will be generated and the program will return to the Option

Selection Menu. All of the information entered and used to make the message

can be seen at the top of the screen.

8. Make sure the FPR-10 interface unit is connected and properly powered up.

Also, make sure the beacon programming window is pointed in the direction of

the front of the interface unit and within 2 feet (60cm) of the interface unit. See

Figure 4.

9. From the Option Selection Menu, click the Program New Hex ID Into Unit

button.

10. There will be a box that will show the message to be sent to the beacon and the

communications port it will use for programming. If all of this information is

correct, click OK, or click CANCEL.

11. Once the PC has sent the information to the FPR-10 interface unit, the green

LED on the FPR-10 will turn on for approximately 15 seconds.

12. Make sure the beacon programming window is pointed toward the front panel

of the FPR-10.

13. Pull the test switch on the beacon once.

14. There will be two short audible beeps from the EPIRB to indicate proper

programming. A message will appear on the screen indicating the FPR-10

interface unit has sent the data.

If there are any problems with the communications between the FPR-10 interface

unit and the PC there will be a message that appears on the screen giving

information on the problem.

5.2

Printing Hexadecimal labels (UIN)

1. Program a new Hex ID into the beacon as described in section 5.1

2. On the Option Selection Menu click the Print Labels button.

3. Click the appropriate button for the top 4 or bottom 4 labels to be printed.

4. If the vessel name is known for the beacon, click the Enter Name of Vessel

button and enter the appropriate text.

5. Click the Click Here to Print Label button to print. The program uses the

printer that is set up as your default Windows printer.

Y1-03-0164 Rev. A