Flisom eFlex 4x1 Manuale di sicurezza e installazione - Pagina 4

Sfoglia online o scarica il pdf Manuale di sicurezza e installazione per Pannello solare Flisom eFlex 4x1. Flisom eFlex 4x1 16.

Version: 01.12

High Voltage

In a PV system the voltage is multiplied by the number of modules in series up to the

stated system voltage. Do not allow the system to exceed the stated system voltage. Be

aware that almost the same voltage stated on the label is present under low light

conditions.

Arcing

PV modules generate direct current when exposed to light. When disconnected a

dangerous arc between the wires may be generated which will not extinguish on its own.

Do not disconnect under load.

Fire Protection

Do not use PV modules in explosive atmospheres. Check the local regulations for fire

protection

Warning

Do not use aggressive solvents or scrubbing materials for cleaning the modules. Do

not use sharps objects. Do not walk on the panels if there is any risk that sharp stones

under the soles, or sharp shoe elements would damage the panel.

The safety instructions for other system components apply. Local standards, building

norms and accident prevention regulations must be followed. Disregarding the

warnings can cause serious injuries or even death.

Keep a minimum distance of 5m

about the PV installation.

Attention

Do not concentrate light on the modules. Modules and insulations can be destroyed by

concentrated light.

Do not remove the label or use modules without labels attached by the manufacturer.

Reverse currents may damage modules. To avoid reverse currents, maintain an

equivalent voltage in each parallel connected string of the circuit.

Do not cut or thin eFlex panels. Do not drive screws into the laminate.

Source: www.arbeit-und-gesundheit.de/2/2349

This manual applies only on Flisom's eFlex Series modules

Safety & Installation Guide

Valid from 22.10.2018

to a burning PV system. Inform the public authorities

FG2P1-4S1P00/1