AMC MOUSE 01 Manuale - Pagina 2

Sfoglia online o scarica il pdf Manuale per Sensori di sicurezza AMC MOUSE 01. AMC MOUSE 01 7. Dual element digital motion detector (dual pyro element + microwave + anti-masking)
Anche per AMC MOUSE 01: Installazione (4 pagine)

AMC MOUSE 01 Manuale
Perform the following steps to mount the detector:
1.Open the
detector
the enclosure (Fig.1).
2. Remove the PCB from the base by releasing the locking clip (Fig.2).
3. Make holes (for mounting the sensor on the wall) in the embossings at the rear or side of the housing. If the
tamper indicating detachment from the wall is used, drill additional hole and screw the cover of the detector
to the wall using additional screw (Fig. 3) and set the jumper accordingly (Fig. 4b). The detector can also be
mounted on the SN-1 rotating holder (not included).
4. Lead the cables through the hole located in the upper part of the enclosure (Fig. 2)
5. Connect the wires to the screw terminals and configure the detector.
(Information on the distribution of terminals and control elements with a description of the available functions
can be found in the following pages)
6. Close the lid of the sensor.
CAUTION! When closing the cover of the detector, check whether the spring of the micro switch tamper is
correctly pressed into the tapered socket in the lid. The field of view of the detector should not be partially or
completely obstructed.
7. Connect the supply voltage and wait until the LED of the sensor stops flashing.
CAUTION! Leave the field of view of the detector.
Mounting the sensor on the wall with the use of tamper indicating detachment from the wall.
Anti-masking function
The MOUSE 01 detector features anti-masking function, which allows to detect any attempt to mask
the sensor. In such a case, the N.C. contact marked as MASK (Fig. 4b) is opened for about two seconds,
which is additionally signaled by a fast pulsing red LED.
The arrangement of the elements of the detector on the PCB is shown in the figure 4a and 4b.
Printed Circuit Board (front view)
by
releasing (using thin screwdriver) the
Fig. 4a
Fig. 3
Printed Circuit Board (rear view)
latch in the
lower part
Fig. 4b
of
2