Amcor AC12HP Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Condizionatore d'aria Amcor AC12HP. Amcor AC12HP 13. Portable air conditioner
Anche per Amcor AC12HP: Manuale d'uso (12 pagine), Manuale d'uso (12 pagine)

Stampa la pagina

INSTALLATION

Warning：Before using this unit, please keep it upright for at least 3-4 hours.

This unit can easily be moved from one room to another.

While moving the unit please note that it must be kept upright and then placed on an even

surface.

3. Twist the hose connector into the exhaust outlet on the rear

of the unit.

INSTALLATION OF WINDOW KIT

2. Make sure the unit is upright and there are no obstructions

to the air inlet grills.

NOTES



To ensure efficient operation the opening should be as small as possible.



The best form of installation is through a wall duct.



The unit will need to be externally in heating mode (AC12HP only), ideally through the

wall. By properly venting you expel cold air from your room while efficiently heating it.



Your air conditioner should be used without a vent hose in dehumidifier mode. Please

ensure an external water tank is used, monitored and regularly emptied before over

spilling. Permanent plumbing can be also installed in dehumidifier mode, alternatively an

external water pump can be fitted for unattended use.

IMPORTANT SAFEGUARDS

The length of the soft hose extends from 28 cm to 150 cm. If the hose is extended above

this length the unit may malfunction and this can invalidate the warranty.

The outlet vent must be well ventilated and not obstructed as this will cause the unit to

overheat. Avoid bending the hose more than 30°.

1. Extend one end of the hose

and connect the hose

connector, by twisting it a

number of full rotations.

2. In the same way connect the

fishtail adapter to the opposite

end of the exhaust hose.

3. With the hose and

fishtail adaptor

connected to the

unit, push the end of

the fishtail adaptor

into the slot in the

slide bar.

The window kit (slide bar and fishtail)

can be used with sliding windows and

doors. For other types of window, the

fishtail should be used on its own.

Partially open the window and then fix

the window kit to fill the opening in the

window.