Amcrest AMC4KBC36-W Manuale di avvio rapido - Pagina 5
Sfoglia online o scarica il pdf Manuale di avvio rapido per Telecamera di sicurezza Amcrest AMC4KBC36-W. Amcrest AMC4KBC36-W 9. 4k analog hdcvi bullet camera
Stampa la pagina
Note: The wall anchors should be in the same bag as the screws and a designed to secure the screws onto the mounting
surface.
3)
Attach the power cable and BNC cabling to the camera. (If you are running the cables through a mounting surface,
use a 1" paddle bit to bore a hole for the cables.)
4)
Place the base of the camera on the wall anchors lining the holes to the mounting surface. Then, using a Phillips
head screwdriver, secure the screws and base of the camera to the mounting surface.
Note: To adjust the camera, you can loosen the adjustment screws near the base of the camera. Adjust the position as
desired and tighten when complete.
Connection
To connect your camera to your DVR, please follow the steps provided below:
Step 1: Connect a BNC (coaxial) cable to the video out connection of your camera.
Step 2: Connect the male end of the DC power connector of the BNC (coaxial) cable to the female end of the power
connector of the camera.
Step 3: Connect the BNC (coaxial) cable to a video out channel on the back of your DVR.
Step 4: Connect the male end of the DC power connector of the power adapter to the female end of the power
connector of the BNC (coaxial) cable. Plug in the power adapter to apply power to the camera.
For more information on the installation process described, refer to the image below for more details.
Audio
The camera has a built-in microphone which allows the camera to transmit one-way audio through a coaxial connection.
To enable the microphone on your camera, please make sure the following settings on your DVR are enabled.
-
In the Management menu, click on Encode to enter the encode settings menu for your DVR.
-
Click on "More Settings" and make sure that the Audio Encode checkbox is enabled.
-
Set the encode settings to AAC and then change the input from "Local" to "HDCVI".
-
Click Save to save the encode settings to your device.
Note: If you are using the system on your mobile device, ensure that the Video Steam checkbox is enabled in the
Sub stream menu of your DVR.
Technical Specifications
Model
Camera
Image Sensor
Effective Pixels
Scanning System
Electronic Shutter Speed
Minimum Illumination
AMC4KBC36-W
1/2" CMOS (OS08A10)
3840(H)×2160(V), 8MP
Progressive
PAL: 1/4s~1/100,000s NTSC: 1/3s~1/100,000s
0.054Lux/F1.6, 30IRE, 0Lux IR on
5