ACR STOVES FB5BK Manuale tecnico - Pagina 6

Sfoglia online o scarica il pdf Manuale tecnico per Stufa a legna ACR STOVES FB5BK. ACR STOVES FB5BK 10.

Stampa la pagina

Instructions for use

• Open the secondary air slider, to the

top left hand side of the door, and

open the primary air slider, to the

bottom left hand side of the door, fully

by sliding them fully right in line with

the body of the stove.

• Lay firelighters or rolled up

newspapers on the grate and add a

small amount of kindling wood to the

top. Place 1 or 2 small logs on the

top.

• Light the newspaper or firelighters

using a long taper and push the door

closed but do not engage the locking

handle fully.

• When the fire is burning fiercely, after a

couple of minutes add more logs and

close the door.

• When the fire has become established,

close the primary air, to the bottom left

hand side of the door, by pushing the

lever left in line with the stove.

• The burning rate can be altered by

moving the secondary air slider, to the

top left hand side of the door – push

the lever towards the left to close

down and pull to the right to increase

the burn rate.

• Care should be taken to ensure that

the logs are not placed in such a way

that may allow the fuel to fall out of the

burning chamber.

Re-fueling

When refueling the stove always refuel

onto a bed of hot embers, fully open the

secondary and primary air controls until

the new fuel is well alight, before

adjusting the air controls for the desired

setting.

If there is insufficient burning material in

the firebed to light a new fuel charge,

excessive smoke emission can occur.

Refueling must be carried out onto a

sufficient quantity of glowing embers

and ash that the new fuel charge will

ignite in a reasonable period. If there are

too few embers in the fire bed, add

suitable kindling to prevent excessive

smoke.

Fuel overloading

Never overload the stove – it will work

very well with three medium sized logs.

The amount of fuel specified in this

manual should not be exceeded,

overloading can cause excess smoke.

Operation with door left open

Operation with the door open can cause

excess smoke and overfirring of the

appliance. The appliance must not be

operated with the appliance door left

open except as directed in the

instructions.

Never leave the stove unattended

until the new fuel is well alight.

Persistent fume emission is dangerous

and must be investigated.

If fume emission persists, open doors

and windows to ventilate the room and

let the fire die out. Have the chimney

inspected for blockages and clean if

required. Do not relight the fire until the

cause has been found. We recommend

that you seek professional advice.

This appliance has been designed to be

burned with the door closed at all times

other than when refueling.

It should not be operated as an open

fire.

Typical refueling intervals for wood is

1 hour and smokeless fuel is 2 hours.

Maintenance

We recommend that the appliance is serviced annually by a competent

engineer to ensure it's continued safe operation.

Daily Maintenance

• The ash pit should be checked and

emptied regularly.

Periodic Maintenance

• The chimney should be swept at least

once a year together with the flue pipe

connection. Care should be taken to

ensure that there is not a build up of

soot on the baffle and in the airways of

the appliance.

• If the appliance has not been operated

for long periods, the flue should be

Commissioning Check List

Please tick boxes when each procedure is completed

Ensure the serial number has been recorded on the front of this manual for any

future use

Ensure the door seals are in good condition and that the glass is secured correctly

in the door (do not over tighten the glass as this will prohibit its expansion and

could cause the glass to crack)

Ensure that all internal components are fitted correctly (these may have shifted in

transit)

Ensure that the appliance operates correctly during the first firing

Ensure the customer is aware that fumes may be given off during the first firings

as the paint cures

Advise the customer on the safe operation of the appliance

Leave the instruction manuals, operating tool and glove for the customer's use.

Record the flue draught reading of the appliance

inspected and swept before use to

ensure there are no blockages within

the flue.

• Check the rope door seals are intact

and are not worn. These should be

replaced on an annual basis to ensure

the correct operation of this appliance.

• The glass can be cleaned using a soft

damp cloth and window cleaner or

ACR stove glass cleaner (available

from your local stockist)

Use only replacement parts

recommended by the manufacturer.