ACR STOVES E900 Manuale di avvio rapido - Pagina 7

Sfoglia online o scarica il pdf Manuale di avvio rapido per Gamme ACR STOVES E900. ACR STOVES E900 9. Electric fireplace insert range

Stampa la pagina

SETTING THE COLOUR FUNCTIONS

• Press the lamp button

• Lamp 1 is for the rear flame

• Lamp 2 is for the base effect

• Lamp 3 is for the log effect

By pressing the lamp buttons, this will change

the colour of the rear flame, base effect and the

log effect separately.

SETTING THE TIME

• Press the CLOCK SETTING button which will

start the DAY curser to blink. Using the

CLOCK UP and CLOCK DOWN buttons to

set the current day e.g. 1-Monday, 2-Tuesday

etc and press CLOCK SETTING to confirm

the required day.

•The hour setting will now be blinking. Adjust

this by using the CLOCK UP and CLOCK

DOWN to reach the present hour and confirm

by pressing CLOCK SETTING.

•The minute setting will now be blinking. Adjust

as per the hour setting.

App Installation and Smart Control

• Your smart phone / tablet must be

connected to WIFI and the insert plugged

in.

• Use the POWER SWITCH and an orange dot

should appear on the fire screen. Do not use

the STAND BY button to

switch this on.

• Download the ACR Stoves

app

• Open the app and click the

already have this App installed for other ACR

electric products then please log in using

your existing details. The App can be used to

operate multiple ACR electric products.

• Input your email address and the App will

send a verification code to your email

address.

• Input the code to create your password.

• Press the Add Device button to add your

device.

ADJUSTING THE TEMPERATURE

While the insert is switched on, use

TEMPERATURE UP and TEMPERATURE

DOWN to set the required room temperature. A

confirmation beep will be audible from the fire.

If the room temperature is already warmer than

the temperature set on the remote control, the

heater will switch off / not come on until the

temperature in the room drops to below that on

the remote control.

ADAPTIVE CONTROL

This works in conjunction with the timer

programme. When Adaptive Control mode is

selected and turned on the fire monitors the

room temperature in relation to the selected

target temperature. If the room temperature is

lower than the selected temperature, the

Adaptive Control facility will instruct the fire to

switch on between 2 to 5 minutes earlier than

the set time this is to ensure that the room is at

the required temperate at the time selected

(please note this may not be possible to

achieve if the room is very large or very cold).

• Scan the QR code by touching the SCAN

symbol and scanning the code below

• E-Fire – ADD

• Connecting to your wifi – select your wifi

network & input the password. You need to

select the 2.4GHZ option.

• Establishing a connection – press the

STANDBY button on the appliance and hold

for around 3 seconds. You should see a red

light appear next to the orange dot in the

middle of the fire screen. The red light will be

blinking quickly at roughly 2 times per

second. When prompted by the App, if the

red light in blinking rapidly, press NEXT.

• Adding your device – wait whilst the App

adds the device. Keep the phone/tablet close

to the appliance whilst it is syncing. If this

fails, repeat steps 7,8 and 9.

• Your device has now been added

successfully. You are ready to use the phone /

tablet to operate the insert.