Coastal Electronic UCONNECT LOCKPICK AIR V1 Manuale di istruzioni per l'installazione e il funzionamento - Pagina 4

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione e il funzionamento per Ricevitore per auto Coastal Electronic UCONNECT LOCKPICK AIR V1. Coastal Electronic UCONNECT LOCKPICK AIR V1 11.

Stampa la pagina

This written guide will detail the connections for the Lockpick harness and provide reference for

general installation and operations. The UCONNECT LOCKPICK AIR is universal for many different

Chrysler/Dodge/Jeep models and individual dash disassembly is not addressed in this manual. Please

consult a local stereo shop for installation assistance or view our installation videos online.

1. Remove the surrounding screen bezel panel(s) and the four screws holding the screen in place.

Next, remove the screen and unplug the large connector on the back. To release the connector,

press on the side of the connector locking tab before lifting the locking bar. As the bar is lifted,

the connector will eject.

The Lockpick harness is simple to install and consists of matching male and female connectors which

are installed in-line with the original factory connection. Plug the factory connector removed earlier

into the matching female Lockpick connector. Finish by plugging the male Lockpick harness connector

back into the previous factory location on the radio screen. When plugging in the connector, leave the

locking bar partially up, then press down on the bar to lock it in. (see pictures above)

2. Route Lockpick harness so that wiring is not crimped or pinched under the radio.

3. The UCONNECT LOCKPICK AIR is a simple Plug-N-Play interface however additional wiring is

labeled and available on your Lockpick harness. These connections may be used for your

aftermarket accessory power needs and video input from an aftermarket rear camera.

are not necessary for a standard installation and should never be connected to your vehicle

wiring.

They are provided for accessories which may connect to your Lockpick.

They include:

REAR CAMERA VIDEO INPUT – Standard RCA video input.

RED – 12V ACC power output (Limit 1 amp)

YELLOW – 12V constant power output

BLACK – Vehicle GROUND connection

ORANGE/BLACK STRIPE – 12V rear camera power output

RED/BLACK STRIPE – 12V additional camera power output (front, left, right, aux, etc.)

4. Lockpick SETUP -

properly set for your vehicle and options desired.

INSTALLATION

Before plugging in your

Lockpick, insure that the switches and controls are

They