10Bar GF1 Manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso per Camera Accessories 10Bar GF1. 10Bar GF1 9. Underwater housing for the panasonic gf1 camera

making a small loop protruding a few mm. The loop can then be grasped between finger and

thumb, to pull the O-ring over the lip.

l Clean the O-ring recess (the square groove where the O-ring sits) with a cotton bud.

l Inspect the O-ring all the way round its surface for damage such as cuts tears or

contamination. This should be done visually and also by feeling the surface texture between

finger and thumb.

IF THE O-RING IS DAMAGED OR SUSPECTED OF BEING DAMAGED, DISCARD

IMMEDIATELY.

spare O-ring is supplied with your housing, or a replacement O-ring can be ordered from 10BAR.

If the O-ring is contaminated or suspected of being contaminated, clean it with a cotton cloth that

is free of all chemicals or contamination. After cleaning inspect the O-ring again.

Once the O-ring has been inspected and verified fit for use, apply a small amount of silicone

grease to the O-ring. The silicone grease must be evenly distributed round the O-ring.

Replace the O-ring into the groove; run a finger round the O-ring, to make sure it is snugly seated

in the groove.

4.4 Key Hole Lock

The Key -hole Lock is simple and easy to use and adding security. Turn the levers of the lock

perpendicular to the wall of the housing until the lock is released on both sides.

Pull out the lid by holding on the grip near the lock.

Use the universal key to insert in between the lid and body near the key hole lock to push off the

lid if necessary

4.5 Mounting the camera in the housing: