Aktino AK410C Installazione rapida - Pagina 2

Sfoglia online o scarica il pdf Installazione rapida per Hardware di rete Aktino AK410C. Aktino AK410C 4.

-48V A
RTN A
-48V B
RTN B
Protective cap
BITS
ALARM IN
-48V A
CLK IN
A
B
RTN A
+
-48V B
-
1
RTN B
S
2
POWER
Multi pair span connector is male; cable is female.
Management Connection
Ethernet 1 female RJ-45 port (located on the back panel) can
be used for local or remote management access. The
Ethernet port automatically is set to either 10BaseT or
100BaseT and auto-sense the polarity of TX/RX (automatic
MDIX). Ethernet 2 port is not available.
Caution To order to comply with the intrabuilding
lightning surge requirements, intrabuilding Ethernet
management wiring must be shielded, and the shield for the
wiring must be grounded at both ends.
The back panel RS232 modem port can be used for local or
remote management access. The port is set for PPP
communication for telnet or AktinoView GUI access.
The front panel Craft port is used for command line access
using a terminal emulator program; AktinoView is not
supported on the craft port except for IP initialization.
Management is generally attached at the CO end.
MSPAN Connection
The MSPAN connector is used to connect the Aktino 4000
to the outside plant pairs. The CO MSPAN cable should be
shielded with a pigtail wire that attaches to the ground lug
just above the MSPAN connector. The RT MSPAN cable's
shield should NOT be connected to ground (leave open).
The MSPAN cable is female. Tie wrap points are available
in several places on the back panel. The MSPAN cable can
be routed to the left or right.
AK4000 Ethernet Product Family
BITS
ALARM IN
CLK IN
A
B
+
-
1
S
2
CRIT
MAJ
MIN
SYS
AUD
VIS
AUD
VIS
AUD
VIS
ID
NC
ALARM
COM
OUT
NO
MULTI PAIR SPAN
Figure 2 AK100S Back Panel
CRIT
MAJ
MIN
SYS
AUD
VIS
AUD
VIS
AUD
VIS
ID
NC
ALARM
COM
NO
Tie wrap points
MULTI PAIR SPAN
MANAGEMENT
ETHERNET 1 ETHERNET 2
Use Ethernet 1 only
Table 1 specifies the standard 50 pin AMP connector pin
assignments.
Table 1 MSPAN Connector Pin Assignments
* Note that only the first four pairs are active on the AK42x
products and only the first eight pairs are active on the
AK41x products.
2
OUT
DS3
MANAGEMENT
IN
OUT
ETHERNET 1 ETHERNET 2
OPEN
GND
MODEM
TIP
Pair 1
26
Pair 2
27
Pair 3
28
Pair 4
29
Pair 5*
30
Pair 6*
31
Pair 7*
32
Pair 8*
33
Pair 9*
34
Pair 10*
35
Pair 11*
36
Pair 12*
37
Pair 13*
38
Pair 14*
39
Document 180-0008-001 R08
MODEM
Ground Lug
RING
1
2
3
4
5
6
7
8
9
10
11
12
13
14