Air & Allied Sales TOKU DIGGER TCD-20 Manuale di istruzioni per l'operatore - Pagina 5

Sfoglia online o scarica il pdf Manuale di istruzioni per l'operatore per Strumenti Air & Allied Sales TOKU DIGGER TCD-20. Air & Allied Sales TOKU DIGGER TCD-20 12.

Stampa la pagina

Hose Connection

Whether there is any dust, or damage to the air connection portion.

Whether the air hose is tight enough.

Operation guide

Maintain good balance on both feet. Keep proper distance from the chisel of the Air Breaker.

Never put your hand near the chisel when using the Air Breaker horizontally.

Push the Air Breaker against the object firmly using the handle before turning the throttle valve down.

Obey the law and safety regulations.

Inspection and maintenance

WARNING

Turn valve cock of the compressor to the stop position first, hold down the throttle and release the excess

pressure in the air hose completely, then disconnect the Air Breaker from the air hose and finally inspect the

Air Breaker.

Inspection and storage for an Air Breaker

Clean the exterior surface using a cloth.

Regularly inspect the tightening torque on the bolts.

Inspect whether there are any cracks or damage in the Air Breaker.

Storage of the Air Breaker

Apply 3 cc of oil from the air inlet. operate the Air Breaker for about 5 seconds after completing work.

Repeat above operation 2-3 times before storing the Air Breaker.

Put a cap on the air inlet of the Air Breaker to prevent any dust or foreign material from entering the

Air Breaker. Keep the Air Breaker in a dry place.

Loss of power/erratic action (possible causes)

1. Reduced compressor output.

2. Excessive drain on air line.

3. Moisture or restricted pipe, hose or fittings.

4. Improper size or poor condition of pipe, hose or fittings.

5. Incorrect shank size of chisel, or excessively worn shank.

6. Free running (or blank blow) can cause damage to the tool. Always hold the tool down to the work.

7. Loosening of side bolts or back head bolts will cause loss of power and can cause damage to the tool.

Periodic inspection of bolt torque at regular intervals (at least once a week if tool is being used regularly)

is recommended.

If everything else appears to be in order, then disassemble tool, replace worn or damaged parts, clean,

reassemble and lubricate.

Replacement parts

Always use GENUINE TOKU TOOL Replacement Parts.

When replacement parts are required, order by Part Number and Description from the Parts List.

[email protected]

Air & Allied Sales (Pacific) Pty Ltd