Euro-Clear BlueSoft-10-SVR34 Manuale - Pagina 9

Sfoglia online o scarica il pdf Manuale per Sistema idrico Euro-Clear BlueSoft-10-SVR34. Euro-Clear BlueSoft-10-SVR34 20. Central household water softening devices with cabinets

Stampa la pagina

Water purification and treatment equipment manufacturer and wholesale distributor

Tel: +36 96 544-240 • Fax: +36 96 544-248 • E-mail: [email protected] • Web: www. euro-clear.eu

montage block (No. 2) and the control head (No. 4). You can find a plastic tube

outlet of ½" on the control head (No. 4). This outlet is the sewage output of the

device. The sewage that comes out must be led into the sewage canal. This can be

done with a plastic pressure resistant stem of ½" (No 5). The plastic stem needs to

be pulled onto the sewage outlet of the controlling head and it must be supported

with a tube pressing chain and it must be led up to the sewage connection with a

slope. The sewage comes out from the device under pressure, but its drainage

must be done with free outflow. The stem must be fixed firmly at the sewage outlet. It

is advised to build in a one-way valve on the soft water side in the network tube.

An electric plug underlaid of 230 V, 50 Hz must be built within 1 m of the device at

the height of the control head so that the electric cable of the water softener (No. 6)

is not tight.

Water comes out from the pre-filtering device (No. 1) during backwash. It is advised

to connect the sewage connection snag into the drain. In this case the sewage water

will come out under pressure, too. The backwash of the filter must be done manually,

so if needed, the rinsing water that comes out can also be led into a convenient

vessel. On the side of the regenerating tank of the water softening device there is an

overflow snag which the superfluous water can get through in case of a breakdown.

The safety overflow snag of the tank can be led to the sewage outlet point by a ½"

pressure resistant plastic tube. The water that eventually comes out does not have

any pressure, so it must be led to the sewage outlet or into the raiser by a slope. The

sewage outlet of operation of the water softening device and the overflow of the

brine tank can be connected to the sewage leading points respecting the following

rules.

In compliance with DIN 1988, the tube of rinsing water and the overflow must be

fixed at the sewage connection point so that the water can flow free. The tube must

be fixed at least 20 mm far away from the highest possible level of sewage water.

Make sure that the sewage tube of the water softener and the overflow tube of

the brine are each connected separately into the sewage water. While

regenerating, the rinsing water that comes out of the control head (4) and has got

high pressure must not get into the brine tank.

BlueSoft Household Water Softener

Euro-Clear Ltd.

Page 9.