Boca Systems Lemur-C Manuale di pulizia - Pagina 3

Sfoglia online o scarica il pdf Manuale di pulizia per Stampante Boca Systems Lemur-C. Boca Systems Lemur-C 5. Routine cleaning procedures

THERMAL PRINT HEAD CLEANING PROCEDURE

The print head should be cleaned periodically to prevent debris from building up on the print element. The required

cleaning interval varies greatly depending on the quality of the ticket stock and the amount of dust entering the print area.

Excessive dirt buildup on the print head will result in reduced quality. Continuing to run the print head in a dirty condition

will reduce its life expectancy, as it is unable to diffuse its heat properly

The following is done with the printer powered off and unplugged from the AC source.

The thermal print head can be removed for cleaning or replacement, as follows:

1. Make sure power is off and the AC cord is disconnected from the printer.

2. DO NOT UNPLUG CABLE FROM PRINT HEAD.

3. Lift up on the cam lock assembly (located above the head mounting block or plate) to

remove pressure from the thermal head.

4. Lift up on the head mounting plate/thermal head to remove.

5. Clean the entire siler thermal print head surface (the side that makes contact with the paper)

with isopropyl alcohol.

6. While the print head is removed move forward with cleaning the platen and SQ load opto (see next page).

Cam Lock

Lever

Head mtg.

Plate

Clean This Surface