DOMPEL CADEIRA NOMAD Manuale di istruzioni - Pagina 4

Sfoglia online o scarica il pdf Manuale di istruzioni per Arredamento per interni DOMPEL CADEIRA NOMAD. DOMPEL CADEIRA NOMAD 6.

ENGLISH

location of installation

Install your Dompel product in a level place with no grooves or splices,

preventing rocking and vibration. The location must be airy and it must not

allow straight sunlight and it must be away from sources of heat (stoves,

ovens, etc.) and flammable products. Do not install your product outdoors.

cleaning and maintenance

Do not use metal spatulas, brushes and cleaning agents such as alcohol, acetone, kerosene, gasoline, bleach,

thinner, solvents, varsol, vinegar or other chemicals or abrasives such as sandpaper or steel brushes.

To easily clean it, use a solution of warm water with a neutral soap and then wipe dry carefully. If chemical products

reach the upholstery, clean as soon as possible, preventing the products from staining or drying the fabric. The

plastic parts can not be washed with boiling water. Chromed metal components can be cleaned with a soft, dry

flannel, and silicone-based automotive wax can be used to increase gloss and durability, in this case perform the

task following the wax manufacturer's instructions. Perform periodic cleaning, accumulated dust affects the beauty

of the product making it difficult to clean the product.

IMPORTANT

Never drag the product, if necessary, ask other person's help to remove the product from the place. Do

not place containers with high temperature on your product, at the risk of damaging plastic parts or the

upholstery.

Remove all the products from the package and follow the steps below

Manually recline the mobile backrest support

using the side handle.

Assemble the backrest (B) on the seat (A): partially insert the 04 backrest screws (M6 x 30-AB) pre-fi-

xed on the part (E) using a 4mm Allen key. IMPORTANT: Check the perfect horizontal alignment of

the backrest in relation to the seat before definitively fixing the screws (final tightening).

Assemble the footrest (C) on the lower part of

the seat (A). Fix the 04 screws (M6 x 35-SX) (G)

pre-fixed to the seat (A) using a 10 spanner.

Merely illustrative images.

Products may suffer changes in its components without prior warning. If any questions, contact Dompel.

security

Avoid accidents. After

unpacking the product, keep

all the pack material out of

children's reach.

Manually fit the (plastic) finishing cover (F) on

the seat back support (A). Observe the perfect

alignment of the cover holes with the support

holes.

Manually fit the headrest (D) onto the backrest

support (B).